Comtrol Logo

 Active Products
 DeviceMaster FreeWire
 DeviceMaster LT
 DeviceMaster PRO/RTS/Serial Hub
 DeviceMaster UP
 DeviceMaster 500
 RocketLinx
 RocketModem IV
 RocketPort EXPRESS
 RocketPort EXPRESS SMPTE
 RocketPort INFINITY
 RocketPort Universal PCI
 RocketPort uPCI Plus
 RocketPort uPCI SMPTE
 RocketPort uPCI 422
 RocketPort 550 uPCI
 RocketPort USB Serial Hub II & III
 Troubleshooting
 Comtrol .iso Files
 Beta Files
 DeviceMaster UP
 IO-Link Master
 EtherNet/IP
 Installation 4-EIP
 Rotary Switch
 Mounting/Installation
+Connecting to the Network
 Connecting the Power
 Setting the IP Address
 Configuring Ports
 Connecting IO-Link Devices
 PortVision DX
 Software
 Documentation
 Troubleshooting
 RocketPort 550 Universal PCI
 Obsolete/Legacy Files
 Warranty
 FTP Administrator - Report Issues

IO-Link MasterConnecting to the Network

The IO-Link Master provides two Fast Ethernet (10/100BASE-TX) M12 connections (4-pin female /D-coded).

Ethernet Connectors
PinSignal

1

Tx+

2

Rx+

3

Tx-

4

Rx-

You can use this procedure to connect the IO-Link Master to the network.

  1. Securely connect one end of the M12 Ethernet cable to EIP 1 or EIP 2.

  2. Connect the other end to the network.

  3. Optionally, you can use the other Ethernet port to daisy-chain to another Ethernet device.

  4. If you did not connect both Ethernet ports, make sure that screw on a connector cap, which was shipped with the IO-Link Master to keep dust and liquids from getting in the connector.

[Note]
Note

Ethernet ports must have an approved cable or protective cover attached to the port guarantee IP67 compliance.
nice color
06/11/14Home | Comtrol Support 
Copyright © 2014 Comtrol Corporation.