home *** CD-ROM | disk | FTP | other *** search
/ NetNews Usenet Archive 1992 #30 / NN_1992_30.iso / spool / sci / electron / 20750 < prev    next >
Encoding:
Text File  |  1992-12-15  |  1.2 KB  |  34 lines

  1. Newsgroups: sci.electronics
  2. Path: sparky!uunet!das.wang.com!wang!pvr
  3. From: pvr@wang.com ()
  4. Subject: Re: Need help with PADS shareware
  5. Organization: Wang Labs, Lowell MA, USA
  6. Date: Tue, 15 Dec 1992 14:23:12 GMT
  7. Message-ID: <BzB1Ap.JB4@wang.com>
  8. References: <1992Dec12.215154.6390@sequent.com>
  9. Sender: news@wang.com
  10. Nntp-Posting-Host: preilley.wiis.wang.com
  11. Lines: 21
  12.  
  13. washer@sequent.com (Jim Washer) writes:
  14.  
  15. >I've been playing with PADS logic and pcb, and have managed to 'capture'
  16. >my schematic, create the netlist, and read it in using pcbshare.
  17.  
  18. >I have not managed to route it (auto route I hope), nor print a postscript
  19. >image of the etch (single sided board).
  20.  
  21.    Did you place the parts?   You can use auto-place, but that is
  22. more complicated.   When you read in the net list all parts are
  23. piled on top of each other at the origin (0,0).   This is at
  24. the lower left of the screen by default.   It can be off the
  25. screen if you have scrolled the drawing area.   To see them
  26. easily zoom in on the origin to blow the parts and use the move
  27. command to pull them where you want.   Then you can use auto-route.
  28.  
  29. Hope that this helps.
  30.  
  31. --
  32. >>>>>>>>>>>> Peter Reilley ..... pvr@wiis.wang.com ..... KA1LAT <<<<<<<<<<<<<
  33.                      Well, that about says it.
  34.