home *** CD-ROM | disk | FTP | other *** search
- Path: sparky!uunet!charon.amdahl.com!amdahl!tetons!sawtooth!gnd
- From: gnd@idaho.amdahl.com (Greg Darnell)
- Newsgroups: comp.sys.ibm.pc.hardware
- Subject: IDE drive reads/writes ok but can't boot?
- Keywords: Gateway 386SX
- Message-ID: <10347@tetons.idaho.amdahl.com>
- Date: 17 Dec 92 18:02:21 GMT
- Sender: usenet@tetons.idaho.amdahl.com
- Organization: Amdahl Corp., Rexburg, ID
- Lines: 30
-
- I had a Maxtor 7120 120MB IDE drive in an old AT, using an IDE controller
- with a BIOS since the AT didn't have user-configurable drive types.
- I upgraded to a 386SX/16 motherboard from a Gateway 2000 machine with
- an AMI BIOS from 1989. When the system powers on, the floppies and
- hard drive all get reset, the hard drive is accessed for just a second,
- then I get the message:
-
- HDD Controller Failure
- Press <F1> to continue
-
- The system will then boot from the floppy fine, and then I can switch
- to C: and run everything as normal. I thought the BIOS on the IDE card
- was the problem, so I tried a normal IDE card without BIOS, with the
- same results. I thought maybe the BIOS wouldn't work with IDE, but it
- turns out the previous owner of the motherboard was using IDE. Using
- Norton's diskedit the boot records and partition tables all look fine.
- Using Norton's calibrate the preliminary tests say there is a HDD
- controller malfunction and it should be replaced, yet both controllers
- work okay with other motherboards.
-
- Does anyone have any ideas on what else to try? The board is made by
- FTK; maybe only certain IDE controllers work with it (seems doubtful)?
- Any magic CMOS parameters that might help (NEAT chipset)?
-
- Thanks in advance
- Greg
- --
- Greg Darnell Amdahl Corporation 143 N. 2 E., Rexburg, Idaho 83440
- UUCP:{ames,decwrl,sun,uunet}!amdahl!tetons!gnd (208) 356-8915
- INTERNET: gnd@idaho.amdahl.com
-