Error writing sector 14 to the new mirror drive.

        Occurs on:  SFT II and TTS.

        Meaning:  This error message indicates that the REMIRROR console
                  command was used to attempt to remirror a drive and
                  the server could not correctly write sector 14 to the
                  new mirror drive.  Although this is not a fatal error,
                  the REMIRROR command will be aborted.

        Cause:  This could be caused by a failure in the new mirror
                drive, Disk Coprocessor board (DCB), controller, or
                connecting cables.

        Solution:  Ensure that the new mirror drive, the DCB, and the
                   controller are properly seated, connected, and
                   powered on.  Also, check that the new mirror drive
                   has been properly COMPSURFed. If nothing wrong can be
                   detected, try to COMPSURF the new drive and then use
                   the PREPARE utility to re-setup the disk mirroring.
                   If this still does not fix the problem, exchange the
                   above mentioned components one by one with known good
                   components until the problem component is found.