home *** CD-ROM | disk | FTP | other *** search
- Newsgroups: comp.sys.ibm.pc.misc
- Path: sparky!uunet!spool.mu.edu!caen!uvaarpa!murdoch!faraday.clas.Virginia.EDU!jav2d
- From: jav2d@faraday.clas.Virginia.EDU (Jason Adams Vanvalkenburgh)
- Subject: Re: help!! MFM -> IDE
- Message-ID: <1992Nov5.013543.25040@murdoch.acc.Virginia.EDU>
- Sender: usenet@murdoch.acc.Virginia.EDU
- Organization: University of Virginia
- References: <jensenjp.720851977@craft.camp.clarkson.edu>
- Date: Thu, 5 Nov 1992 01:35:43 GMT
- Lines: 27
-
- The card (IDE) costs very little, only about $20 for a cheap
- card from taiwan. The advantage is that the card is NOT a
- hard disk controller - it is an interface card.
-
- The hard disk controllder is "embedded" in the hard drive electronics.
- The disk is low-level formatted at the factory, so you won't have to worry
- about that stuff (remembering bad areas, etc). With the controller built
- in, the drive/card arrangement is much more reliable.
-
- I don't know if this goes for all MFM drives, but the MFM drive I used
- to have required special device drivers for different partitions. I also
- had to use proprietary software for low level formatting and the like.
- All the IDE drive needs is the proper settings in the CMOS setup, and you're
- off!
-
- This may be unrelated, but my several Seagate MFM drives were tempermental:
- sometimes they'd work and sometimes they wouldn't. Their IDE replacements
- (Seagate as well) have performed flawlessly, even under MORE strenuous
- environments.
-
- -jason vanValkenburgh
- jav2d@virginia.edu
- --
- Jason A. vanValkenburgh
- University of Virginia
- ACC MicroConsultant
- jav2d@virginia.edu
-