home *** CD-ROM | disk | FTP | other *** search
/ NetNews Usenet Archive 1992 #26 / NN_1992_26.iso / spool / comp / sys / ibm / pc / hardware / 29650 < prev    next >
Encoding:
Text File  |  1992-11-12  |  1.9 KB  |  41 lines

  1. Newsgroups: comp.sys.ibm.pc.hardware
  2. Path: sparky!uunet!dcatlas!joet
  3. From: joet@dcatlas.dot.gov (Joe Trott)
  4. Subject: Re: problem with pctools
  5. Message-ID: <1992Nov12.155014.10973@dcatlas.dot.gov>
  6. Organization: U.S Dept. of Transportation
  7. References: <721156012.2@altern8.mi>
  8. Date: Thu, 12 Nov 1992 15:50:14 GMT
  9. Lines: 30
  10.  
  11. Bob.Dickey@altern8.mi.org (Bob Dickey) writes:
  12.  
  13. >MG>a friend of mine uses PCTOOLS 7.1 with a 31MB-RLL-Harddisk. The disk is set
  14. >MG>to type 2 in the CMOS-setup ( 614 cyln, 4 heads, 17 sectors, 20MB ). All
  15. >MG>worked fine until PC-CACHE, SI or DISKFIX is started. PC-CACHE reports a
  16. >MG>difference betwenn the bios-settings and the real settings, DISKFIX won't
  17. >MG>analyze the disk and SI reports a 59,4 MB disk with 781 cyln and 6 heads.
  18.  
  19. >MG>I tried to fix this problem with fdisk from DROS but it says 59,6 MB, too.
  20. >MG>I thought, the settings for any harddisk is stored in the cmos and nowhere
  21. >MG>else, but there must be some other place, because fdisk and si shows exactly
  22. >MG>the same ( wrong ) values.
  23.  
  24. >MG>What could I do to repair this disk ?? DISKFIX reports a bad bootblock or
  25. >MG>diagnostic-block, but all other programs work and the disk does boot.
  26.  
  27. >You don't say if its on a 286 or not. My 286 CMOS is set up with OUT the HD
  28. >on it. I don't understand this but it works. It sees it when booting up and
  29. >everything. It is a Seagate HD, I think. Someone was playing with my CMOS
  30. >setup and put my HD in. It would NOT work when the HD was put on the CMOS.
  31. >I don't understand it but I wont change any of the CMOS to show the HD. I
  32. >sugjust not putting you HD in your CMOS. Maybe that will work, why I don't
  33. >know, though. Any comments.
  34.  
  35. This is because you are using an 8-bit XT hard disk controller that has its
  36. own BIOS.  In this case, you tell your PC-BIOS that *no* hard disk(s) is/are
  37. installed.  Better yet, buy a 16-bit controller and then set your PC-BIOS to
  38. the correct parameters.
  39.  
  40. -JTT
  41.