home *** CD-ROM | disk | FTP | other *** search
Wrap
From: David.Norman@ttlg.UUCP (David Norman) Sender: postmaster@ttlg.UUCP Path: sparky!uunet!wupost!gumby!destroyer!ubc-cs!alberta!ttlg!postmaster Newsgroups: comp.sys.ibm.pc.hardware Subject: Need help with WD Controller card Message-ID: <715919988.2@ttlg.ttlg.UUCP> Date: 07 Sep 92 09:40:54 mst Lines: 36 Hello Gregory! 03 Sep 92 07:54, Gregory Sroka wrote to All: GS> From: gsroka@leland.Stanford.EDU (Gregory Sroka) GS> groups: comp.sys.ibm.pc.hardware Subject: Re: Need help with WD Controller GS> card Organization: DSG, Stanford University, CA 94305, USA GS> @Message-ID: <1992Sep3.075438.23471@leland.Stanford.EDU> GS> @References: <q-knf9#.bob@netcom.com> GS> Date: Thu, 3 Sep 92 07:54:38 GMT GS> GS> In article <q-knf9#.bob@netcom.com> bob@netcom.com (Bob Becker) writes: GS> >> I have a Western Digital MFM (I think) controller card. The model >> appears to be WD1006V-SR2. I cannot get it to respond to a >> hard drive. The only pins that are jumpered are 1 & 2 of W1. >> W1 has pins 1-6, and W2 thru 5 are two pins each. >> Can anyone tell me which pins to connect to enable 2 floppy >> drives and two hard drives? >> >> Any help will be appreciated. >> Thanks! >> >> GS> GS> Ooops. That's an RLL controller, isn't it? GS> GS> -+- Fred-Uf 1.8k GS> + Origin: Passed through TTLG: UUCP <> ProgNet gateway (42:1000/2.0) GS> The card is set up for two hard drives. Just plug them in. You have to tell cmos that you have a second drive. You have to format it with the bios on the card. Use debug to get to the rom, Address is cc00:5 I think, If you have problems I will check for you. The jumpers will only disable the cache floppys and the address of the card. --David * Origin: Dave's Place - Edmonton Alberta (42:100/37)