In article <Bu0M37.Ayv@watserv1.uwaterloo.ca> kvetzal@watarts.uwaterloo.ca (Ken Vetzal) writes:
>I have a problem using MS-Kermit under OS/2. Whenever I try it (in either an OS/2 full screen session or a DOS full screen session), I get a message saying:
>Warning: no hardware for this serial port. This port will be operated through the Bios as BIOS1.
>I am trying to use COM2, but OS/2 apparently thinks it doesn't exist, and
>performance is very slow when the port is operated through the Bios. Two
>other points: 1) This problem doesn't occur when I use PM Terminal.
>2) This problem doesn't occur if I boot to DOS5 instead of OS/2.
>Any advice or suggestions is much appreciated.
Try the new COM drivers, available via anonymous ftp from
ftp-os2.nmsu.edu. Look for commga.zoo (roughly correct).
--
Timothy F. Sipples | The OS/2 FREQ. ASKED QUESTIONS LIST is avail. from
sip1@ellis.uchicago.edu | 128.123.35.151, anonymous ftp, in /pub/os2/all/faq.
Dept. of Econ., Univ. | Or from LISTSERV@BLEKUL11.BITNET (send "HELP").