home *** CD-ROM | disk | FTP | other *** search
- Path: sparky!uunet!zaphod.mps.ohio-state.edu!sol.ctr.columbia.edu!ira.uka.de!chx400!urz.unibas.ch!doelz
- From: doelz@urz.unibas.ch
- Newsgroups: vmsnet.networks.tcp-ip.multinet
- Subject: Repost: SLIP configuration problem
- Message-ID: <1992Aug20.124504.40053@urz.unibas.ch>
- Date: 20 Aug 92 12:45:04 MET
- References: <1992Aug10.095438.37877@urz.unibas.ch>
- Organization: University of Basel, Switzerland
- Lines: 46
-
- Has anyone sucessfully managed to run SLIP over LAT yet ?
-
-
- Any hint welcome.
- Regards
- Reinhard
-
-
-
- In article <1992Aug10.095438.37877@urz.unibas.ch>, doelz@urz.unibas.ch writes:
- > I would like to run the following setup:
- >
- > +--------------------+
- > | | +-----------------+ +--------+
- > | Multinet 3.0 | | DECServer 200 |=============| UNIX PC|
- > | | +--------+--------+ 19200 bd +--------+
- > +---------+----------+ !
- > ! Ethernet !
- > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
- >
- > In order to do this, I followed Aaron Leonard's cookbook and did a
- > LATCP> create service gate_sl0 /ID
- > create port lta9960 /dedicated
- > set port lta9960 /dedicated /service=gate_sl0
- > $ define/system slip0 lta9960:
- > $ set term/passall/perm slip0
- >
- > and/after logged in to the vax via LAT,
- > $ mu set/inter sl0/slip=slip0/up
- >
- > The only sad thing is that this doesn't work.
- > I set up the interface as static SLIP, with slip0 as terminal device.
- >
- > Any hints mostly appreciated.
- > Regards
- > Reinhard
- >
- >
- > ************************************************************************
- > Dr. Reinhard Doelz * RFC doelz@urz.unibas.ch
- > Biocomputing * DECNET 20579::48130::doelz
- > Biozentrum der Universitaet * X25 psi%022846211142036::doelz
- > Klingelbergstrasse 70 * FAX x41 61 261- 6760 or 267- 2078
- > CH 4056 Basel * TEL x41 61 267- 2076 or 2247
- > ************************ S W I T Z E R L A N D *************************
- >
-