home *** CD-ROM | disk | FTP | other *** search
- Path: sparky!uunet!psinntp!arrl.org
- From: rhealy@arrl.org (Rus Healy, NJ2L)
- Newsgroups: rec.autos.tech
- Subject: Re: Radar detectors into fuse box
- Message-ID: <434@arrl.org>
- Date: 18 Aug 92 15:38:57 est
- Organization: American Radio Relay League
- Lines: 45
-
- In rec.autos.tech, jimf@centerline.com (Jim Frost) writes:
- >dibb@dg.UUCP (James Dibb) writes:
-
- >>hard-wiring [radar detectors] incorrectly will damage them.
- >
- >>Specifically the Uniden RD9XL uses a 9V supply obtained via
- >>a small
- >>transformer in the cigarette lighter plug, therefore cutting
- >>the
- >>plug off and splicing it into a 12V supply will probably
- >>damage the unit.
- >[stuff deleted]
- >
- >You could also disassemble the plug, extract the transformer, and
- >replace it somewhere along the power line. You'd probably want to box
- >the transformer and add a fuse.
- >
- >Are you sure it uses a transformer? I think I would have used a
- >voltage regulator. You can pick up new 9V regulators that can handle
- >12V inputs at Radio Shack for a couple of bucks.
-
- Radar detectors and other devices that drop an automotive supply
- (usually more than 13.8 V when the vehicle is running, and between
- 12.5 and 13 when it's off) *do not use transformers.* Transformers
- are ac-operated devices and have very low dc resistance. If you
- connect a transformer to a dc supply, you'll toast it in the blink
- of an eye.
-
- Virtually all lower-voltage (ie, 9-V) devices use linear voltage
- regulators to derive the required supply voltage. In such devices,
- a considerable amount of power is wasted as heat. Take this into
- consideration if you decide to repackage a voltage regulator to
- free up your cigarette lighter. Adding a fuse, as Jim Frost
- suggests, is an excellent idea.
-
- If you question the correct operating voltage for your radar
- detector or other accessory, check the panel near the power
- connector. It usually includes the required supply voltage and
- a polarity legend for the power connector. There's no standard
- when it comes to which side of the connector is positive and which
- is negative, so make sure you know which is which before you power
- the thing up!
-
- --Rus
-
-