home *** CD-ROM | disk | FTP | other *** search
- Newsgroups: comp.os.ms-windows.setup
- Path: sparky!uunet!munnari.oz.au!titan!titan!smadden
- From: smadden@titan.trl.OZ.AU (Steve Madden)
- Subject: Re: problems with NCSA Telnet
- Message-ID: <1992Dec16.105840.5932@trl.oz.au>
- Sender: root@trl.oz.au (System PRIVILEGED Account)
- Organization: Telecom Research Labs, Melbourne, Australia
- References: <mcdonald.596@aries.scs.uiuc.edu> <1992Dec8.060158.18663@midway.uchicago.edu>
- Date: Wed, 16 Dec 1992 10:58:40 GMT
- Lines: 29
-
- spcberto@psyche.spc.uchicago.edu (Robert Osterlund) writes:
-
- >I run NCSA Telnet in 386 Enhanced mode windows all the time, without any
- >problems, as follows:
-
- >I don't load the packet driver in either CONFIG.SYS or AUTOEXEC.BAT.
- >Rather, my TELNET.PIF runs TELNET.BAT, which loads the packet driver in
- >a DOS virtual machine, then loads NCSA Telnet.
-
- >Before hitting upon this configuration, I had the problems you described.
-
- >Hope this helps. If you need any more details (like a copy of the PIF
- >settings--but these are not so important as the trick described above--
- >or a copy of the TELNET.BAT), e-mail me and I reply via e-mail.
-
- >Bob Osterlund
- >berto@clio.spc.uchicago.edu
- >SSPPCC--University of Chicago
-
-
- Or try getting a copy of pktmux off Simtel-20, its pktmux11.zip I think.
- This allows up to four simultaneous accesses to the packet driver (so
- you can run Telnet, ftp, lpr, and LPQ all at the same time under
- windows). An *ExcellanT* piece of software. Enjoy !!!
-
- /~~~\ !
- \___ !--- ___ . . ___ ###########################
- \ ! /___> \ / /___> # smadden@titan.trl.OZ.AU #
- \___/ \__/ \___ \/ \___ ###########################
-