home *** CD-ROM | disk | FTP | other *** search
- Newsgroups: comp.dcom.sys.cisco
- Path: sparky!uunet!boulder!recnews
- From: William "Chops" Westfield <billw@regal.cisco.com>
- Subject: Re: slip connectivity
- In-Reply-To: Your message of Mon, 23 Nov 92 13:13:00 PST
- Message-ID: <722562429.7850@news.Colorado.EDU>
- Sender: news
- Date: 23 Nov 92 14:13:07 PST
- Approved: news
- X-Note1: mail msgid was <CMM.0.90.2.722556787.billw@regal.cisco.com>
- X-Note2: message-id generated by recnews
- Lines: 11
-
- The AUX port can run slip starting in SW release 9.0. This is intended
- for network managment, downloading new images to flash, and stuff like
- that. You cannot use the aux port as an async network interface and
- route over it. (This is on the wishlist for a future release. It is
- NOT in 9.0, and is NOT in 9.1)
-
- In 9.1, the Comm Servers support routing over their async lines, but
- still not the aux port...
-
- Bill Westfield
-
-