CD-Recorder Manufacturers
Note: This information is provided without any warranty and
may not be complete. All names may be trademarks or registered trademarks of
their respective owners. If
your CD-Recorder is not listed, you can simply try. If your writer is listed,
please check for required firmware.
This list assumes CloneCD Version 2.8.5.2
Back to Hardware Requirements
Firmware:
- If nothing is specified, any firmware version will work. However, the
newest firmware version available is recommended.
- Rev. >= X.X : Firmware version X.X or better is required
- Rev. = X.X : The exact Firmware version X.X is required. Any other version
WILL NOT WORK.
Best Write Mode:
- RAW-DAO 96 = 2352 bytes RAW Data + 96 Bytes
P-W Subchannel Data. This is the best mode for CloneCD. It allows writing of
all subchannel information, including Digital Signatures, CD-Text, ISRC,
Catalog Numbers, CD+G, CD+Midi, Gaps, Indices and Crazy TOCs.
- RAW-DAO 16 = 2352 bytes RAW Data + 16 Bytes
P-Q Subchannel Data. This is the second best mode for CloneCD. It allows
writing of most subchannel information, including most Digital Signatures,
ISRC,
Catalog Numbers, Gaps, Indices and Crazy TOCs.
- RAW-SAO = 2352 bytes RAW Data. This is the
third best mode for CloneCD. Feature support is drive dependant. ISRC,
Catalog Numbers and Indices can be written. Usually CD-Text, CD+G and
CD+MIDI can be written as well. Crazy TOCs and Digital Signatures can't be
written in this mode.
- SAO = 2352 bytes error corrected Data.
This is the worst mode for CloneCD. Writing of ISRC, Catalog Numbers,
Indices and usually CD-Text is supported. Not yet implemented, will be
supported in CloneCD 3.x
- - = Writing to this drive is not supported. CloneCD will not recognize the
drive as a CD-Recorder.
Buffer under run Technology:
= Drive offers a buffer under run
technology like BurnProof or JustLink. This option can be
controlled by the user.
= Drive offers Seamless
Link buffer under run
technology. Seamless Link is always
enabled and can not be switched off.
= Drive offers a buffer
under run technology, but the current CloneCD version does not support this
feature yet. It is very likely, that this feature will be supported in the
future.
= Drive offers a buffer under run
technology like BurnProof or JustLink, but this option does
not work with CloneCD RAW writing and MUST be turned off!- - = Drive does not offer any buffer under run technology
Correct EFM encoding of regular bit patterns
- = Drive writes regular bit patterns
correctly
- - = Drive does not write regular bit patterns correctly
Best Read Mode:
- RAW+96 = 2352 bytes RAW Data + 96 Bytes P-W
Subchannel Data. This is the best mode for CloneCD. Reads all subchannel
information like ISRC, Catalog Numbers, CD+G, CD+MIDI, Gaps, Indices,
Digital Signatures.
- RAW+16 = 2352 bytes RAW Data + 16 Bytes
P-Q
Subchannel Data. This is the second best mode for CloneCD. Reads most
subchannel information like Gaps, Indices and most Digital Signatures.
- RAW = 2352 bytes RAW Data. No Subchannel Data
can be read.
- - = Reading from this drive is not supported.