![]() | ![]() |
|
LED | Description | |
---|---|---|
PWR The PWR or Power LED is on the reverse side from the serial connectors. |
If lit, the PWR or Power LED indicates the DeviceMaster PRO has power and completed the boot cycle. The PWR or Power LED flashes while booting and it takes approximately 15 seconds for the Bootloader to complete the cycle. When the Bootloader completes the cycle, the LED has a solid, steady light that blinks approximately every 10 seconds. | |
|
If the LNK/ACT LED is lit, it indicates a working Ethernet connection. | |
COL |
If the red COL LED is lit, there is a network collision. | |
100 |
If the 100 LED is lit, it indicates a working 100 MB Ethernet connection (100 MB network, only). If the LED is not lit, it indicates a 10 MB Ethernet connection. | |
RX/TX |
The RX (yellow) and TX (green) LEDs function accordingly when the cable is attached properly to a serial device.
|
Configure the DeviceMaster PRO IP address.
![]() |
![]() | 06/11/14 | Home | Comtrol Support | ![]() | |
![]() | Copyright © 2014 Comtrol Corporation. | ![]() |