home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
The Unsorted BBS Collection
/
thegreatunsorted.tar
/
thegreatunsorted
/
texts
/
anarchy_text_a-l
/
fuses1.txt
< prev
next >
Wrap
Text File
|
1992-03-27
|
3KB
|
80 lines
MAFiA presents...
HOW TO MAKE GOOD FUSES FOR ALL YOU DUMB
K-RAD ELITESTERS
WRITTEN BY: BIG VITO AND ICE CUBE
-+ Part I +-
Fast Burning Fuses
The burning rate of this fuse is approximately 40 in. (100
cm) per minute.
Material Required:
-----------------
/
Soft Cotton String / Potassium Nitrate 25 parts
Fine Black Powder ------ or < Charcoal 3 parts
Piece of Round Stick \ Sulphur 2 parts
Two Pans or Dishes \
[PAUSE]
Procedure:
---------
1. Moisten fine Black Powder to form a paste or prepare a
substitute as follows:
A. Dissolve Potassium Nitrate in an equal amount of
water.
B. Pulverize charcoal by spreading thinly on a hard
surface and rolling the round stick over it to crush to
fine powder.
C. Pulverise the sulphur in the sam manner.
D. Dry mix sulphur an charcoal.
E. Add Potassium Nitrate solution to dry mix to obtain
a thoroughly wet paste.
2. Twist of braid three strands of cotton string together.
3. Rub paste mixture into twisted string with fingers and
allow to dry.
4. Check the actual burning rate of the fuse by measuring the
time it takes for a known legth to burn. This is used to
determine the lenght ned for the desired time.
-+Part II+-
Slow Burning Fuses
The burning rate of the fuse is approximately 2 in. per
minute.
Material Required:
-----------------
Cotton String or 3 Shoelaces
Potassium Nitrate or Potassium Chlorate
Granulated Sugar
Procedure:
---------
1. Wash cotton string or shoe lace in hot soapy water; rinse
in fresh water.
2. Dissolve 1 part Potassium Nitrate or Potassium Chlorate
and 1 part granulated in 2 parts hot water.
3. Soak string or shoelace in solution.
4. Twist or braid three strands of string and allow to dry.
5. Measure the actual buring rate like said above.
*-* NOTE *-*
The last few inches of this cord (the end inserted in the
material to be ignited) should be coated with the fast
burning Black Powder Paste if possible. This MUST BE DONE
when the fuse is used to ignite the blasting cap.
<-------------------------------------------------------->
> THIS WAS PRESENTED BY MAFiA ALL RIGHTS WORTH JACK SHIT <
<-------------------------------------------------------->