home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Phoenix Rising BBS
/
phoenixrising.zip
/
phoenixrising
/
cellular
/
hthmot.doc
< prev
next >
Wrap
Text File
|
1993-11-21
|
3KB
|
68 lines
The High Tech Hoods Presents...
MOTOROLA RE-PROGRAMMING FOR ALL
OF THE MOTOROLA PHONES!
Written By The Punisher
Ok well it seems that everyone jumped on the scene to get our Motorola
Software but we were not finished! Actually we did not release the
instructions for it. No matter what you tried if you were trying to do
a new model phone you got fucked! Anyway Here's what you did'nt know you
had to do:
In order to do the newer Motorola flip, Microtac and Lite phones you will
need the Software that we've let out, and the special 'trick clip', this
process requires you to open the phone. Since that's a pain in the ass
look for updates that will let you do it with out opening up the phone.
Anyway When you open the phone you will find the 27C512 chip. This chip
is the shit that you'll be getting ready to alter. This chip is sometimes
blacked out to prevent identifying it. Now you'll need to either do one or
both of the following in order to get this stuff started:
You can order the clip from HTH Technologies for $285
or you can build it fromthe instructions that will soon follow you can
order the parts from HTH Technologies or anybody else that will have them.
To build this 'trick clip' order the IC TEST CLIP #50F1528, Type 5733
I think Digikey also sells them but if you ordered crystals from them
then you know there bullshit with backorder.
Attach the 213 Series Chip Carrier Socket. Use the diagram 2 to jumper
the pins correctly.
Place an M27C512 - 15XC1 PROM in the socket that has been programmed with
the Motorola.BIN software that could be found on the New York Hack Exchange
BBS or any good H/P BBS.
When programming the phone you'll still keep the cables the same and have
the clip hooked onto the prom.
Diagram #2 30
v
l l l l l l l
----------------------------
- ! O!_
- ! !_
! !
! !_
- ! !_
- ! !- <- 5
! 27C512 CHIP !
- ! !-
! !
- ! !-
- ! !-
- ! !-
----------------------------
l l l l l l l
Pin 5 (on the Quad clip) is not connected to the top chip holder.
It is jumpered to PIN 30. Pin 5 on the chip holder is jumpered to
Pin 7 on the chip holder.
If you have any questions or Problems then you can reach me at :
The New York Hack Exchange BBS (718) 379-4702 and leave me mail.
You can get the HTH Technologies # and Address off of the New York
Hack Exchange.
THE PUNISHER