home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
World of Ham Radio 1997
/
WOHR97_AmSoft_(1997-02-01).iso
/
mods
/
yaesu
/
ft890_aa.doc
< prev
next >
Wrap
Internet Message Format
|
1997-02-01
|
2KB
From amsoft@epix.net Thu Aug 10 15:32:01 1995
Path: grape.epix.net!sc2c526a.ra.osd.mil!nova.sti.nasa.gov!lerc.nasa.gov!magnus.acs.ohio-state.edu!math.ohio-state.edu!cs.utexas.edu!not-for-mail
From: MUENZLERK@uthscsa.edu (Muenzler, Kevin)
Newsgroups: rec.radio.amateur.equipment
Subject: Yaesu FT-890 mods
Date: 10 Aug 1995 10:03:09 -0500
Organization: UTexas Mail-to-News Gateway
Lines: 34
Sender: nobody@cs.utexas.edu
Message-ID: <01HTWKCH2IXU001GUU@uthscsa.edu>
NNTP-Posting-Host: news.cs.utexas.edu
YAESU FT890/AT mod. TX 1,5 to 30 MHZ.
======================================
- Disconnect FT890 from all connections.
- Open tranceiver like explained in your "OPERATING MANUAL".
- Locate on the "CONTROL UNIT" jumper point JW 3001 and close it with
solder.
- Close tranceiver back and reconnect power.
- Push PROC, AGC-F, IPO, ATT while power ON.
- Now the display shows two digits of numbers and tree of letters (i.e 13
OFF)
Rotate main knob and set the display to "02 ON". Now press the PROC
button.
- Power OFF and then back ON. It's all!
- Now every time you want, you can change the programation, but you will
allways lose the memories.
- Other settings than "02 ON" are of no interest. This one give you 100 w
and automatic antenna tuning between 1,5 and 30 mhz.
==========================================================
I found this on one of the newgroups a few months ago. I haven't tried it
proceed at your own risk.
Kevin, WB5RUE
muenzlerk@uthscsa.edu