home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
ftp.tcs3.com
/
ftp.tcs3.com.tar
/
ftp.tcs3.com
/
DRIVERS
/
Network
/
3COM
/
3C5x9
/
3c5x9x.exe
/
NDIS
/
3OPEN.TXT
next >
Wrap
Text File
|
1994-01-18
|
2KB
|
55 lines
3Com NDIS 2.01 driver installation notes for 3+ Open
3Com's EtherLink III adapters are not directly installable into 3+Open
Environments. To utilize these adapters in a 3+Open environment it is
necessary to use 3Com's NETSETUP program and select one of the other
listed 3Com adapters, then modify CONFIG.SYS, PROTOCOL.INI and copy the
appropriate EtherLink III driver to the workstation or server's boot
device. 3Com recommends you select the 3C523 adapter from NETSETUP's
list of adapters and make the following modifications.
(NOTE: This example is for a default 3+OPEN DOS ENHANCED WORKSTATION.
The exact files copied and directory paths may vary depending on your
particular installation.)
1) Modify the CONFIG.SYS file:
Change
DEVICE=C:\3OPEN\DOSWKSTA\LANMAN\DRIVERS\ELNKMC.DOS
To
DEVICE=C:\3OPEN\DOSWKSTA\LANMAN\DRIVERS\ELNK3.DOS
2) Use the DOS Change Directory Command, CHDIR or CD to move to the
drivers subdirectory:
CD C:\3OPEN\DOSWKSTA\LANMAN\DRIVERS
3) Copy the EtherLink III NDIS, ELNK3.DOS driver from the ETHERDISK's
\NDIS\DOS subdirectory to this directory:
COPY A:\NDIS\DOS\ELNK3.DOS C:
4) Modify your PROTOCOL.INI file:
In the ADAPTERS section add the following
[ETHERLINK3]
DRIVERNAME = ELNK3$
In the PROTOCOLS section
Change all
BINDINGS = ETHERLINK/MC
To
BINDINGS = ETHERLINK3
%VER 3OPEN.TXT - NDIS 2.01 3+ Open installation notes V 3.4b