home *** CD-ROM | disk | FTP | other *** search
- ===============================================================================
-
-
- All In One Box
-
- BY:
-
- Disk Doctor
-
-
- ==============================================================================
-
-
- Basicly, this should be common sense.. All You have to do is by a small
- box (Preferable a rated box that will keep it from interfering with
- that nice Raidio you carded last week <grin>)
-
- If you want to be real cheap about it you can go with just a plywoord
- box... But I highly suggest you use a PC case.. or something that will
- not burn (Overloads?)
-
- Then simply assemble that boxes discussed in this file.. Now after you
- do that.. You're gonna have alot of boxes cluttering the old room. What
- to do? Simple.. Getcha a powersupply.. And some switches (on/off) from
- Raidio Shack (Yes pay for them.. They're not that expensive) Now.. if
- you buy you a bread board. (Cards kits can be picked up anywhere. And
- this is the type you should use) Then simply install the box on one of
- these. And incase them in the PC case. Now.. You can drill a hole in
- the case and run the line in there.. and likewise have another hole
- drilled for the line to run back out (Phone that have a hook up for
- more than one regular line can give you some of the parts)
-
- Next install the cards.. You *MUST* Use a low voltage power supply
- (These boxes don't need much if any.. And make sure that you check the
- voltage in the circuit.. You can run it to a light bulb if you need
- someplace to disperse some of it!
-
- No the simple task.. Where the Disk Drives normaly go simply Hook you
- up some on off switches.. So that you can easily switch between the
- boxes.. This will make life SOOOOOO much easier... I promise..
-
- Also if you want to make it easier with the phone lines you can aphro engineer
- a line in. IE run the phone line in to box along the back with them being fully
- exposed.. IE
-
- -------------------------------
-
- ----------------------------------
-
-
- This allows for a sort of switching system as it were. After this is done..
- Simple solder wires where need and run them to the appropriate box.. you may
- then hook a lever (Like you see in those old Frakenstein movies) to the box to
- allow box priorty over the line..
-
- All in all this is pretty simple shit. But just some ideas for you to play
- with....
-
-
-
-
- Later
-
- Doc
-