home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
ftp.wwiv.com
/
ftp.wwiv.com.zip
/
ftp.wwiv.com
/
pub
/
DOOR
/
CELEB40.ZIP
/
ERROR.QB
< prev
next >
Wrap
Text File
|
1995-02-12
|
3KB
|
72 lines
QuickBasic Error codes
DoorFrame uses the QB error codes.
---------------------------------------------------------------------------
The following file was compiled and written by Dennis Maidon,
PAROLE Software and may not be used or distributed without expressed
written permission from Dennis Maidon. Copyright 1991-94, PAROLE
Software --- all rights reserved.
---------------------------------------------------------------------------
2 Syntax Error 61 Disk full
5 Illegal Function Call 62 Input past end of File
6 Overflow 63 Bad record number
7 Out of memory 64 Bad filename
11 Division by Zero 67 Too many files
13 type mismatch 68 Device unavailable
24 Device Timeout 69 Comm-buffer overflow
25 Device fault 70 Permission denied
52 Bad filename or number 71 Disk not ready
53 File Not Found 72 Disk media error
55 File Already open 74 Rename across disk
57 Device I/O error 75 Path/File access error
58 File already exists 76 Path not found
59 Bad Record length
The most common error that you will see is #62. This is usually caused
by the CFG file not having enough lines. I have included this list so
that you may be able to fix a problem that occurs with a PAROLE Software
door.
486DX CPU's
-----------
The math coprocessor in 486DX CPUs cannot handle floating point math which
all MicroSoft Basic's use. This can show up as an ERROR 5, a keyboard
timeout, etc.
Fortunately there is an easy fix for this problem. Simply place the following
line in the AUTOEXEC.BAT file:
SET NO87=ON
This will inform DoorFrame to use a different timing routine. If you are
operating under DESQview/X, you must flag the MATH COPROCESSOR as being ON.
If the door seems to operate fine on the BBS end but the remote cannot
receive or receives garbled info, check and make sure you are passing the
correct IRQ to the door. Com 1 and 2 are standard and as such, you do
not need to pass the IRQ to them.
If you are operating under DESQview, you will need to load DVANSI in
each window.
Error #75 is usually an incorrect path and/or filename in the CFG file.
Please check the filenames and paths in your CFG file(s). They *MUST* be
correct in order for the door to operate.
Unless you are using a Digi-board and need a fossil driver, DO NOT use
the "/FD" switch on the command line. The doors do not need a fossil
driver to operate on serial ports.
If you are operating under Wildcat! 4.x, you will need to specify
DOOR.SYS on line #1 of the CFG file. WC!4 no longer creates or supports
USERINFO.DAT.
NOTE: If you have not run the INSTALL.BAT on a new installation, please
do not call me for support. I include this batch file for a
reason, to install the door properly.
Revised: 7/10/94