home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Dr. Windows
/
1993_Aces_Research_Dr._Windows_UPC_765872322017_shareware.iso
/
video
/
gss1000.exe
/
READ.ME
< prev
Wrap
Text File
|
1992-02-04
|
3KB
|
82 lines
DGIS*34010 Version 3.06 for the GSS 1000 Series
January 31, 1992
===============================================
The following files haven been shipped on this diskette:
READ.ME - This file.
INSTDGIS.BAT - Batch file to install DGIS files in a hard
disk directory.
DGIS.EXE - This is the host resident portion of the
GSS 1000 Series firmware.
DGIS.OUT - This is the display adapter resident portion
of the GSS 1000 Series firmware.
HWCONFIG.EXE - The program which allows the user to specify
the monitor and resolution that the firmware
will configure to.
HWCONFIG.INF - A file containing input data for HWCONFIG.EXE.
The valid monitors and resolutions are listed
here.
GSP800.OUT - File needed by HWCONFIG.EXE during diagnostics.
GSP1024.OUT - File needed by HWCONFIG.EXE during diagnostics.
@0F5F.ADF - File needed during Microchannel installation.
LCA.BIN - File needed during GSS 1000 Series setup.
AT1050.SYS - A small device driver installed during the boot
process once you have inserted the command to
load it in your CONFIG.SYS file.
INSTALLING AND CONFIGURING DGIS
===============================
To install DGIS on your hard drive, for example in C:\DGIS, do the following:
a) Ensure that the card is plugged into the computer's bus.
b) Place this disk in your computer's floppy drive and
enter the commands:
A:
INSTDGIS C:\DGIS<CR>
The DGIS files will be copied to the specified directory and
the configuration program will configure DGIS for your system.
In addition, a file called AUTOEXEC.NEW will be written to the
C:\DGIS directory. This file will contain the commands which you
would need to add to your AUTOEXEC.BAT file if you would like
DGIS to be installed automatically when your system boots up.
c) Add the commands in AUTOEXEC.NEW to your AUTOEXEC.BAT so DGIS is
automatically installed when you turn on your system. If you do
not add the commands in AUTOEXEC.NEW into your AUTOEXEC.BAT file
you will have to manually install DGIS each time that you powerup
your system.
d) Add any commands in CONFIG.NEW to your CONFIG.SYS file.
DGIS.EXE Command Line Options
=============================
/r<filename> -- Specify a fully-qualified path and filename for the
DGIS remote executable (default is DGIS.OUT in the
current directory).
/c<filename> -- Specify a fully-qualified path and filename for the
DGIS configuration file (default is HWCONFIG.CFG in
the current directory).
/x -- Remove previously loaded DGIS.