home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Black Box 4
/
BlackBox.cdr
/
genapps
/
btu.arj
/
BTUCOM1.DAT
< prev
next >
Wrap
Text File
|
1990-06-18
|
2KB
|
63 lines
Page 1 of 1
BTU Heating/Cooling Analysis
01-29-1990
A to Z Unlimited
901 Ferndale Blvd.
High Point, NC 27262
****************************************************************************
****************************************************************************
This analysis prepared especially for: John Doe
John Doe
1234 Anywhere Ct.
High Point, NC 27260
*********** HEATING ***********
The heating outside design temperature is 10 degrees fahrenheit.
The heating inside design temperature is 72 degrees fahrenheit.
The heating temperature differential is 62 degrees fahrenheit.
The heat loss for this building is 79,616 BTU's.
The heating unit must handle 904 CFM's for proper heating.
Any heating unit must be rated as close as possible to the heat loss
calculated in this study, but not less than that amount.
The above CFM allows an 80 degrees rise in inlet to outlet air temperature.
*********** COOLING ***********
The cooling outside design temperature is 95 degrees fahrenheit.
The cooling inside design temperature is 72 degrees fahrenheit.
The cooling temperature differential is 23 degrees fahrenheit.
The heat gain for this building is 43,101 BTU's.
This translates into 3.6 tons of cooling.
The preferred cooling CFM is 1,293 CFM's for proper cooling.
For high humidity areas use 1,077 CFM's
For normal humidity areas use 1,293 CFM's
For low humidity areas use 1,508 CFM's
Any cooling unit must be rated as close as possible to the heat gain
calculated in this study, but not less than that amount.
****************************************************************************
The writers of the software that was used in generating the above in-
formation assumes no responsibilities for any losses that may be
incurred by the use of the above information.