WA dual attachment station was configured as a single attachment station.
EA single attachment station cannot be configured as a dual attachment station.
EThe value specified for the attachmentclass parameter in the PROTOCOL.INI file is not correct.
EThe microcode file %1 could not be opened.
EThe microcode file %1 could not be read.
EThere is not enough storage to read the microcode file.
EThe value specified for the parameter %1 in the PROTOCOL.INI file is not correct.
IThe IBM FDDI adapter is starting. Please wait.
EThe IBM FDDI adapters are not set to the same interrupt level.
IThe universally administered address of the IBM FDDI adapter is %1.
IThe IBM FDDI adapter is using a locally administered address of %1.
EThe IBM FDDI adapter will not operate in this computer.
EThe value specified for the LERcutoffA parameter in the PROTOCOL.INI file is not correct.
EThe value specified for the LERcutoffB parameter in the PROTOCOL.INI file is not correct.
EThe value specified for the LERalarmA parameter in the PROTOCOL.INI file is not correct.
EThe value specified for the LERalarmB parameter in the PROTOCOL.INI file is not correct.
EThe microcode could not be loaded on the IBM FDDI adapter.
EA checksum error occurred while attempting to load the microcode onto the IBM FDDI adapter.
EThe value specified for the userdata parameter in the PROTOCOL.INI file is not correct.
EAn error occurred while attempting to initialize the microcode on the IBM FDDI adapter.
EAn IBM FDDI adapter diagnostic test failed.
EThe universally administered address was not found on the IBM FDDI adapter.
WDuplicate device driver statements were found in the CONFIG.SYS file.
EThe required parameter drivername was not found in the PROTOCOL.INI file.
EThe IBM FDDI NDIS device driver could not open the NDIS protocol manager file.
EThe IBM FDDI NDIS device driver could not register with the NDIS protocol manager.
EThere is no IBM FDDI Adapter installed in this computer.
WThe unrecognized parameter %1 was found in the PROTOCOL.INI file.
WThe local address that is specified for the IBM FDDI adapter in the PROTOCOL.INI file is not correct. The universally administered address will be substituted.
IThe IBM FDDI NDIS device driver version %1
EThe value specified for the PMFpassword parameter in the PROTOCOL.INI is not correct.
EThe value specified for the TReq parameter in the PROTOCOL.INI file is not correct.
EThe value specified for the TVX parameter in the PROTOCOL.INI file is not correct.
EThe value specified for the TMax parameter in the PROTOCOL.INI file is not correct.
EThe value specified for the TMin parameter in the PROTOCOL.INI file is not correct.
IInitialization is starting for section %1 in the PROTOCOL.INI file.
EThis version of the microcode for the IBM FDDI adapter is not supported.
EThere is not enough system memory to load the IBM FDDI NDIS device driver.