home *** CD-ROM | disk | FTP | other *** search
- #
- # This file is used for selecting non-standard netcard options, and
- # need not be modified for typical use.
- #
- # Drivers are *not* selected in this file, but rather with files
- # automatically generated during the top-level kernel configuration.
- #
- # Special options supported, indexed by their 'config' name:
- #
- # CONFIG_WD80x3 The Western Digital (SMC) WD80x3 driver
- # WD_SHMEM=xxx Forces the address of the shared memory
- # WD_no_mapout Don't map out the shared memory (faster, but
- # your machine may not warm-boot).
- # CONFIG_NE2000 The NE-[12]000 clone driver.
- # PACKETBUF_MEMSIZE Allows an extra-large packet buffer to be
- # used. Usually pointless under Linux.
- # show_all_SAPROM Show the entire address PROM, not just the
- # ethernet address, during boot.
- # rw_bugfix Patch an obscure bug with a version of the 8390.
- # CONFIG_HPLAN The HP-LAN driver (for 8390-based boards only).
- # rw_bugfix Fix the same obscure bug.
- # CONFIG_EL2 The 3c503 EtherLink II driver
- # EL2_AUI Default to the AUI port instead of the BNC port
- # no_probe_nonshared_memory Don't probe for programmed-I/O boards.
- # EL2MEMTEST Test shared memory at boot-time.
- # CONFIG_PLIP The Crynwr-protocol PL/IP driver
- # INITIALTIMEOUTFACTOR Timing parameters.
- # MAXTIMEOUTFACTOR
- # D_LINK The D-Link DE-600 Portable Ethernet Adaptor.
- # D_LINK_IO The D-Link I/O address (0x378 == typical)
- # D_LINK_IRQ The D-Link IRQ number to use (IRQ7 == typical)
- # D_LINK_DEBUG Enable or disable D-Link debugging
- # DEPCA The DIGITAL series of AT Ethernet Cards (DE100, DE200)
- # DEPCA_IRQ Set the desired IRQ (=0, for autoprobe)
- # DEPCA_DEBUG Set the desired debug level
- #
-
- # The following options exist, but cannot be set in this file.
- # lance.c
- # LANCE_DMA Change the default DMA to other than DMA5.
- # 8390.c
- # NO_PINGPONG Disable ping-pong transmit buffers.
-
-
- # Most drivers also have a *_DEBUG setting that may be adjusted.
- # The 8390 drivers share the EI_DEBUG settting.
-
- # General options for Space.c
- OPTS = # -DETH0_ADDR=0x300 -DETH0_IRQ=11
-
- WD_OPTS = #-DWD_SHMEM=0xDD000
- EL2_OPTS = #-DEL2_AUI
- NE_OPTS =
- HP_OPTS =
- PLIP_OPTS =
- DEPCA_OPTS = -DDEPCA_IRQ=0 -DDEPCA_DEBUG=1
-
- # The following are the only parameters that must be set in this file.
- DL_OPTS = -DD_LINK_IO=0x378 -DD_LINK_IRQ=7 -UD_LINK_DEBUG
-