home *** CD-ROM | disk | FTP | other *** search
-
- Q: There are so many bootdisks! Which one should I use?
-
- A: Here's a little table to help you decide. In each box, the best choice
- will be at the top of the list. Other disks you might try if the recommended
- choice doesn't work are preceded by a (*). If you can't install directly from
- your CD-ROM, you might consider copying the disk directories onto your hard
- drive on a DOS or HPFS partition and installing from there.
-
- -- Pat
-
-
- ----------------\ Target hard drive type:
- Slackware \
- source on: \ IDE SCSI MFM
- -------------------+----------------+--------------------------+--------------
- Hard Drive | bare.i | Use a SCSI controller | xt.i
- | | bootdisk from the list |
- | | below. |
- -------------------+----------------+--------------------------+--------------
- SCSI CD-ROM | Use a SCSI | Use a SCSI controller |
- | controller | bootdisk from the list |
- | bootdisk from | below. |
- | the list below.| |
- -------------------+----------------+--------------------------+--------------
- IDE/ATAPI CD-ROM | bare.i | Use a SCSI controller |
- | | bootdisk from the list |
- | | below. |
- -------------------+----------------+--------------------------+--------------
- Aztech, Orchid, | aztech.i | old_cd.s |
- Okano, Wearnes, | | |
- Conrad, CyCDROM | | |
- non-IDE CD-ROM | | |
- -------------------+----------------+--------------------------+--------------
- Sony CDU31a, | cdu31a.i | old_cd.s |
- Sony CDU33a CD-ROM| | |
- -------------------+----------------+--------------------------+--------------
- Sony CDU531, | cdu535.i | old_cd.s |
- Sony CDU535 CD-ROM| | |
- -------------------+----------------+--------------------------+--------------
- Philips/LMS cm206 | cm206.i | old_cd.s |
- CD-ROM | | |
- -------------------+----------------+--------------------------+--------------
- Goldstar R420 | goldstar.i | old_cd.s |
- CD-ROM | | |
- -------------------+----------------+--------------------------+--------------
- Mitsumi non-IDE | mcdx.i | old_cd.s |
- CD-ROM | mcd.i | |
- -------------------+----------------+--------------------------+--------------
- Optics Storage | optics.i | old_cd.s |
- 8000 AT CD-ROM | | |
- ("Dolphin") | | |
- -------------------+----------------+--------------------------+--------------
- Sanyo CDR-H94A | sanyo.i | old_cd.s |
- CD-ROM | | |
- -------------------+----------------+--------------------------+--------------
- Matsushita, | sbpcd.i | old_cd.s |
- Kotobuki, | | |
- Panasonic, | | |
- CreativeLabs | | |
- (Sound Blaster), | | |
- Longshine and | | |
- Teac non-IDE | | |
- CD-ROM | | |
- -------------------+----------------+--------------------------+--------------
- NFS | net.i | scsinet.s |
- -------------------+----------------+--------------------------+--------------
- Tape | bare.i (for | Use a SCSI controller | xt.i (for
- | floppy tape) | bootdisk from the | floppy tape)
- | | list below. |
- | For SCSI tape, | |
- | use one of the | |
- | SCSI bootdisks | |
- | listed below. | |
- | | |
- -------------------+----------------+---------------------------------------
-
- SCSI controller bootdisks: 7000fast.s acard.s advansys.s aha152x.s aha1542.s
- aha1740.s aic7xxx.s am53c974.s buslogic.s dtc3280.s eata_dma.s
- eata_isa.s eata_pio.s fdomain.s gdt.s ibmmca.s in2000.s initio.s
- iomega.s megaraid.s n53c4xx.s n_5380.s n_53c7xx.s n_53c8xx.s
- no_kbd.s no_pci.s old_cd.s pas16.s pci2000.s qlog_fas.s
- qlog_isp.s scsi.s scsinet.s seagate.s sgivis.s smp.s sym538xx.s
- tekram.s trantor.s ultrastr.s
-
- If you have no idea which SCSI controller your machine has, you can also
- try the generic SCSI bootdisk "scsi.s". You can determine what controller
- type you have by watching the boot messages. Then, you should make the
- bootdisk that matches your controller and use that to install. (Since the
- scsi.s kernel is loaded with SCSI drivers, it consumes quite a bit of memory
- that the disks designed for a single SCSI controller do not)
-
-