home *** CD-ROM | disk | FTP | other *** search
- Blowgun by The Jolly Roger
-
- In this article I shall attempt to explain the use and manufacture
- of a powerfull blow-gun and making darts for the gun.The possesion of
- the blow gun described in this article IS a felony.
- So be carefull where you use it. I don't want to get you all busted.
-
- Needed:
-
- 1. Several strands of yarn (About 2 inches a-piece)
- 2. A regular pencil
- 3. A 2 1/4 inch long needle (hopefully with a beaded head. If not
- obtainable,wrap tape around end of needle.
- 4. 2-3 1/4 foot pipe. (PVC or Aluminum) Half a inch in diameter
-
- Constructing the dart:
-
- 1st- Carefully twist and pull the metal part (Along with eraser)
- of the pencil till it comes off.
- 2nd- Take Pin and start putting about 5-7 Strands of yarn on the pin. Then
- push them up to the top of the pin. But not over the head of the pin (orthe tape).
- 3rd- Push pin through the hollow part of the head where the pencil was before.
- 4th- That should for a nice looking dart. (see illustration)
-
- #####
- >>>>>-----/ # is the yarn
- > is the head of the pencil
- - is the pin it-self
- / is the head of the pin
-
- Using the Darts:
-
- 1st- Now take the finished dart and insert it in the tube
- (if it is too small put on more yarn.)
- 2nd- Aim the tube at a door, wall, sister, ect.
- 3rd- blow on the end of the pipe.
- 4th- Sometimes the end of the pipe may be sharp. When this happens I
- suggest you wrap it with some black electrician tape.It should feel
- a lot better.
- -------Jolly Roger
-
-
- Downloaded From P-80 International Information Systems 304-744-2253
-