home *** CD-ROM | disk | FTP | other *** search
- Installing the shareware version
- ▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀
-
- If you received Graphic Workshop as a ZIP file, do the following
- to install it automatically:
-
- 1. Create a blank, formatted floppy disk capable of holding at
- least 720 kilobytes of data.
- 2. Unpack the contents of the Graphic Workshop ZIP file onto the
- floppy disk.
- 3. Follow the instructions in the next section. Treat the floopy
- disk you have unpacked Graphic Workshop onto as your Graphic
- Workshop master.
-
- Note that the shareware version of Graphic Workshop does not
- include GWSCAP.ZIP or ACCESS.ZIP.
-
- Unpacking these files
- ▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀
-
- The quickest way to install Graphic Workshop on your hard drive is
- to log into the floppy drive with your Graphic Workshop master
- disk in it and type:
-
- SETUP ─┘
-
- This will run an interactive setup function to unpack your files
- and configure the software.
-
- Note that this will install the GWSCAP screen capture program on
- your hard drive as well. It will not install the accessory disk
- contents. These are stored in ACCESS.ZIP on your Graphic Workshop
- master disk, and must be unpacked manually, as discussed next,
- if you require them.
-
- Manual unpacking
- ▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀▀
- If you'd like to unpack Graphic Workshop by hand, do the following:
-
- 1. Create a subdirectory on your hard drive to put it in.
- 2. Log into this subdirectory.
- 3. Type:
-
- A:ZIPPER A:GWSDOS ─┘
-
- or
-
- B:ZIPPER B:GWSDOS ─┘
-
- This will unpack Graphic Workshop.
-
- Note that you can use PKUNZIP to unpack GWSDOS.ZIP as well.
-
- You might also want to unpack GWSCAP.ZIP and ACCESS.ZIP, the Graphic
- Workshop screen capture and accessory disk contents respectively.
-