home *** CD-ROM | disk | FTP | other *** search
- Newsgroups: comp.dcom.sys.cisco
- Path: sparky!uunet!charon.amdahl.com!pacbell.com!ames!saimiri.primate.wisc.edu!zaphod.mps.ohio-state.edu!sol.ctr.columbia.edu!ira.uka.de!gmd.de!Germany.EU.net!mcsun!sunic!ugle.unit.no!runit.sintef.no!al
- From: al@runit.sintef.no (Arne Langmo)
- Subject: Serial link AGS/2 to IGS.
- Message-ID: <1992Nov6.171220.29166@ugle.unit.no>
- Keywords: AGS/2, IGS, E1
- Sender: news@ugle.unit.no (NetNews Administrator)
- Reply-To: al@idt.unit.no (Arne Langmo)
- Organization: University of Trondheim, Norway
- Date: Fri, 6 Nov 92 17:12:20 GMT
- Lines: 99
-
- We have set up a link beetween an AGS/2 and IGS/R. This was suppost
- to use a 2Mb/s modem connection. But to make it work, the speed of the
- link had to set down to 512Kb/s.
- At 1 Mb/s IP- DECnet- and AppleTalk-routing worked, but to get bridging
- work we had go down to 512.
-
- Before the ciscos was installed, the link was used by 2 Vitalinks.
- They reported no errors on the link at 2 Mb/s.
-
- So the question is then:
- Is it the AGS/2 or IGS/R that can not handle 2 Mb/s with IP, DECnet, AT
- and bridging.
-
-
- This is the config:
- --------------------
- GS Software (GS2-BRX), Version 8.3(3)
- Copyright (c) 1986-1992 by cisco Systems, Inc.
- Compiled Mon 30-Mar-92 15:09 by mlw
-
- System Bootstrap, Version 4.4(2)
-
- CSC2 (68020) processor with 1024K bytes of memory.
- X.25 software.
- Bridging software.
- 4 MCI controller.
- 8 Ethernet/IEEE 802.3 interface.
- 2 Serial network interface.
- 32K bytes of non-volatile configuration memory.
-
- MCI 3, controller type 1.1, microcode version 1.8
- 128 Kbytes of main memory, 4 Kbytes cache memory
- 22 system TX buffers, largest buffer size 1520
- Restarts: 0 line down, 0 hung output, 0 controller error
- Interface 0 is Ethernet6, station address aa00.0400.78dd
- 15 total RX buffers, 11 buffer TX queue limit, buffer size 1520
- Transmitter delay is 0 microseconds
- Interface 1 is Serial0, electrical interface is V.35 DTE
- 15 total RX buffers, 11 buffer TX queue limit, buffer size 1520
- Transmitter delay is 0 microseconds
- High speed synchronous serial interface
- Interface 2 is Ethernet7, station address 0000.0c01.92c4
- 15 total RX buffers, 11 buffer TX queue limit, buffer size 1520
- Transmitter delay is 0 microseconds
- Interface 3 is Serial1, electrical interface is V.35 DTE
- 15 total RX buffers, 11 buffer TX queue limit, buffer size 1520
- Transmitter delay is 0 microseconds
- High speed synchronous serial interface
-
- !
- interface Serial 1
- ip unnumbered Ethernet0
- bandwidth 500
- decnet cost 10
- decnet hello-timer 120
- appletalk address 1820.1
- appletalk zone AVH
- bridge-group 1
- bridge-group 1 lat-compression
- bridge-group 1 output-type-list 201
- !
- access-list 201 permit 0x6001 0x0000
- access-list 201 permit 0x6004 0x0000
- access-list 201 permit 0x6007 0x0000
- access-list 201 permit 0x8040 0x0000
- access-list 201 permit 0x8041 0x0000
- access-list 201 permit 0x6002 0x0000
-
- ----------------
- IGS-BR Software, Version 8.3(1),
- Copyright (c) 1986-1991 by cisco Systems, Inc.
- Compiled Tue 22-Oct-91 01:30 by block
-
- System Bootstrap, Version 4.4(1),
-
- cisco IGS (68020) processor (revision D) with 512K/512K bytes of memory.
- Processor board serial number 00239220
- Bridging software.
- 1 Ethernet/IEEE 802.3 interface.
- 1 Serial network interface.
- 16K bytes of non-volatile configuration memory.
- !
- interface Serial 0
- ip unnumbered Ethernet0
- bandwidth 1000
- delay 20
- decnet cost 10
- decnet hello-timer 120
- appletalk address 1820.2
- appletalk zone AVH
- bridge-group 1
- bridge-group 1 lat-compression
- bridge-group 1 output-type-list 201
- !
-
- -----------
- Arne Langmo
- SINTEF Runit
- NORWAY
-