home *** CD-ROM | disk | FTP | other *** search
- Path: sparky!uunet!portal!lll-winken!sol.ctr.columbia.edu!usc!wupost!emory!athena.cs.uga.edu!aisun3.ai.uga.edu!mcovingt
- From: mcovingt@aisun3.ai.uga.edu (Michael Covington)
- Newsgroups: sci.electronics
- Subject: Re: why is one prong on plug wider than the other?
- Message-ID: <1992Oct9.012645.17219@athena.cs.uga.edu>
- Date: 9 Oct 92 01:26:45 GMT
- References: <1992Oct8.205505.16186@husc3.harvard.edu>
- Sender: news@athena.cs.uga.edu
- Distribution: usa
- Organization: AI Programs, University of Georgia, Athens
- Lines: 26
-
- In article <1992Oct8.205505.16186@husc3.harvard.edu> mlevin@husc8.harvard.edu (Michael Levin) writes:
- >
- > I am holding a plug, which is supposed to plug into a wall socket.
- >One of the two metal prongs is wider, so that the plug only fits one
- >way - not if you turn it over. Why is this? I thought the whole point
- >of AC was that the poles change sinusoidally; so how can one be
- >different from the other? Please direct replies to
- >mlevin@husc8.harvard.edu.
-
- One side of the line is grounded to the earth so that the potential between
- line and ground will never be excessively high; this is a safety measure.
-
- Switches and fuses should always be in the *ungrounded* side of the line,
- so that when a switch opens or a fuse blows, the whole piece of equipment
- will be at ground potential. Otherwise, even with the fuse blown, the
- equipment could still present a shock hazard to someone in contact with
- the ground.
-
- The wider side of the plug is the grounded side.
-
-
- --
- :- Michael A. Covington internet mcovingt@uga.cc.uga.edu
- :- Artificial Intelligence Programs phone 706 542-0359
- :- The University of Georgia fax 706 542-0349
- :- Athens, Georgia 30602 U.S.A. amateur radio N4TMI
-