home *** CD-ROM | disk | FTP | other *** search
- Newsgroups: sci.electronics
- Path: sparky!uunet!cs.utexas.edu!torn!skule.ecf!manson
- From: manson@ecf.toronto.edu (Bob Manson)
- Subject: Help with autoplace of parts in PADS package
- Message-ID: <BuJHLy.IJ2@ecf.toronto.edu>
- Organization: University of Toronto, Engineering Computing Facility
- Date: Sun, 13 Sep 1992 23:08:22 GMT
- Lines: 11
-
-
- I have a question about the PADS package. I tried making a schematic
- diagram and then importing it into the PCB layout program. It reads the
- schematic, but it lumps everything in the lower left hand corner of the
- screen. If I "create" a board and try to autoplace the components, they end
- up in a jumble on top of one another. I rtfm'd, but obviously didn't find
- the answer. Is there a set-up problem? If so, is it in the schematic
- capture part of the program, or the pcb part?
-
- any help would be much appreciated
- bob
-