home *** CD-ROM | disk | FTP | other *** search
/ NetNews Usenet Archive 1992 #20 / NN_1992_20.iso / spool / comp / sys / zenith / 775 < prev    next >
Encoding:
Internet Message Format  |  1992-09-09  |  1.9 KB

  1. Path: sparky!uunet!gatech!purdue!yuma!longs.LANCE.ColoState.EDU!pm860605
  2. From: pm860605@longs.LANCE.ColoState.EDU (Peter Mckinney)
  3. Newsgroups: comp.sys.zenith
  4. Subject: Re: 1490 FTM Monitor whines
  5. Message-ID: <Sep09.191311.85986@yuma.ACNS.ColoState.EDU>
  6. Date: 9 Sep 92 19:13:11 GMT
  7. References: <1992Sep9.172725.21450@magnus.acs.ohio-state.edu>
  8. Sender: news@yuma.ACNS.ColoState.EDU (News Account)
  9. Reply-To: pm860605@longs.LANCE.ColoState.EDU (Peter Mckinney)
  10. Organization: Engineering College, Colorado State University
  11. Lines: 28
  12.  
  13. In article <1992Sep9.172725.21450@magnus.acs.ohio-state.edu>,
  14. hcolijn@magnus.acs.ohio-state.edu (Hendrik O Colijn) writes:
  15. > I have a Zenith 1490 FTM monitor that has developed a VERY
  16. > annoying whine from (I assume) the flyback transformer.  Can
  17. > anyone suggest a fix.  The whine is so bad that the computer is
  18. > virtually unusable.
  19. > Thanks, Henk
  20. > -- 
  21. > ============================================================================
  22. > Henk Colijn             The Ohio State University
  23. > colijn.1@osu.edu        Campus Electron Optics Facility
  24.  
  25.         I had an older Zenith CGA monitor that developed a whine
  26. after a while.  The problem turned out to be a bad solder joint
  27. on one of the boards.  After enough use and poor cooling, one
  28. solder joint finally became loose enough so that it would
  29. oscillate at an audible frequency.
  30.         The solution was to try and pinpoint the area it was
  31. coming from and re-solder everything in that area.  Alternatively,
  32. one could "poke" at various likey bad (oscillating) solder joints
  33. (with a non-conductor :-) ) in an attempt to find the culprit.
  34. The inside of a monitor is *not* a safe place however, and caution
  35. *must* be used near the high voltages at back end of the tube.
  36.         This isn't a slick solution, but it worked for me.  Good luck,
  37.  
  38.                                 - Pete McKinney
  39.                                 - pm860605@longs.LANCE.ColoState.Edu
  40.