home *** CD-ROM | disk | FTP | other *** search
- Path: sparky!uunet!wupost!darwin.sura.net!europa.asd.contel.com!emory!wmorse
- From: wmorse@mathcs.emory.edu (William Morse)
- Newsgroups: comp.sys.sun.hardware
- Subject: Please help: Sun 3/60 probs...
- Keywords: Sun, monitor, cg3, help
- Message-ID: <9383@emory.mathcs.emory.edu>
- Date: 24 Aug 92 00:40:13 GMT
- Organization: Emory University, Dept of Math and CS
- Lines: 58
-
- Please help me if you can...
-
-
-
- We have a cg3 board in our Sun 3/60... Problem is, we have
-
- no monitor. I understand that if the 3/60 does not "see" a
-
- monitor attached, it should go to serial port A. But it doesn't.
-
- Are there any dip switch settings that need to be altered? What
-
- type of monitors will use the cg3?
-
-
-
- We tried pulling the board... no effect.
-
-
-
- We tried using the "u" command at the PROM prompt...
-
- Specifically, we used the command ua9600, but again, there
-
- was no effect. What is the proper syntax for this command...
-
- Is there a way to save our choice to PROM?
-
-
-
- There is a port labled "MONO" (not MONO/OPTION) on
-
- the back of the 3/60... I believe this the TTL port for the
-
- SUN 19 inch mono monitor.. is this correct?
-
-
-
- Any other advice?
-
-
-
- I really could use your help.
-
-
-
- Thanks...
-
-
-
- William Morse
-
-
- --
- William Morse
- Emory University, Atlanta, GA
- Internet: wmorse@mathcs.emory.edu BITNET: wmorse@emory.bitnet
- UUCP: {rutgers,gatech}!emory!wmorse
-