home *** CD-ROM | disk | FTP | other *** search
/ NetNews Usenet Archive 1992 #19 / NN_1992_19.iso / spool / comp / sys / ibm / pc / hardware / 22484 < prev    next >
Encoding:
Internet Message Format  |  1992-08-23  |  1.5 KB

  1. Path: sparky!uunet!news.gtech.com!noc.near.net!ds5000!cellis
  2. From: cellis@ds5000.DAC.Northeastern.edu (Charles Ellis)
  3. Newsgroups: comp.sys.ibm.pc.hardware
  4. Subject: Re: Help installing Toshiba 5 1/4" drive (1.2M)
  5. Keywords: floppy drive
  6. Message-ID: <7326@ds5000.DAC.Northeastern.edu>
  7. Date: 24 Aug 92 01:00:19 GMT
  8. References: <parduse.920822194912@eng.auburn.edu>
  9. Organization: Northeastern University, Boston MA. USA 02115
  10. Lines: 30
  11.  
  12. In article <parduse.920822194912@eng.auburn.edu>, parduse@eng.auburn.edu (Stephen E. Pardue) writes:
  13. > I recently aquired a used Toshiba 1.2M 5 1/4" floppy that I would
  14. > like to install in my pc. I have been trying to install it as the a:
  15. > drive. The system boots fine with the drive installed. When I chnage to
  16. > the a drive it spins up and comes back with a Not Ready error. I previously
  17. > had a Qume 360k drive as a: and it worked fine.
  18. > The system I'm running:
  19. >     286 clone (1989 AMI bios)
  20. >     1.44M floppy as b:
  21. >     ST-225 Hard drive (20M seagate MFM)
  22. > Hopefully its just a jumper configuration problem, I don't have any
  23. > documentation for this drive. Thanks in advance.
  24. >                             Steve
  25.  
  26. ----------
  27. It's probably one of two things:
  28.  
  29. 1) Have you run your CMOS Setup routine to tell it that the A: drive is
  30.    1.2 Mb instead of the 360 Kb that was previously installed?
  31.  
  32. 2) If that doesn't work, it's either a jumper change or a tiny switch
  33.    somewhere on the drive, to set it to drive A:  (possibly drive 0 if the
  34.    choice is dr0 or dr1). Some drives have these markings right on the 
  35.    circuit board.
  36.  
  37.  
  38.  
  39.