home *** CD-ROM | disk | FTP | other *** search
- Newsgroups: comp.os.ms-windows.setup
- Path: sparky!uunet!van-bc!rsoft!agate!ames!sun-barr!cs.utexas.edu!sdd.hp.com!mips!mips!munnari.oz.au!bruce.cs.monash.edu.au!monu6!giaeb!s1110238
- From: s1110238@giaeb.cc.monash.edu.au (Lee Hollingworth)
- Subject: Re: "Windows Aware" only Fullscreen?
- Message-ID: <s1110238.714219316@giaeb>
- Sender: news@monu6.cc.monash.edu.au (Usenet system)
- Organization: Monash University, Melb., Australia.
- Date: Wed, 19 Aug 1992 10:15:16 GMT
- Lines: 26
-
- I have just re-installed Windows 3.0 onto my hard disk, and wished to
- re-install my MS-DOS based software which is written in a "windows
- aware" manner, (ie runs in a window), for example Kermit 3.11, and
- Archive (windows based but uses pkzip etc).
-
- However I have found that windows will now no longer allow me to run
- these programs in anything but fullscreen. When I installed windows
- before, these programs worked without any problems.
-
- Obviously I have something set differently now than I did on previous
- installations, but I cannot work out what.
-
- Any suggestions would be greatly appreciated.
-
- If it makes any difference, my system is configured as follows:
- IAC 80386DX
- 4Mb RAM
- 200Mb IDE Hard drive
- MS-DOS 5.0
- MS-Windows 3.0
-
- Installation was done using setup with default options.
-
- Lee Hollingworth
- s1110238@giaeb.cc.monash.edu.au
-
-