home *** CD-ROM | disk | FTP | other *** search
- MWRFN Menu: MWALS
- =============================================================================
- Refines the corner between multi-layer walls and the joints between
- straight wall segments.
-
-
- Description
-
- When two multi-layer walls meet at a corner, the system "miters"
- the corner along the line that bisects the angle between the two walls.
- You may use this command to produce a more "architectural"
- solution. It results in one of the walls being "dominant"
- over the other. The "dominance" controls which wall will penetrate
- the corner to the outer face of the second wall.
-
- The system selects the dominant wall using the following criteria:
-
- for walls of differing heights the higher wall
-
- for level walls of the same height the wall aligned closer to the x axis
-
-
- for sloping walls of the same height the wall whose opposite end is higher
-
- This command also removes the vertical lines from the wall surface
- between two multi-layer walls that meet on a continuous axis (straight line).
-
- NOTE: 1 This operation depends on the angle between the two walls. If it
- exceeds 135 degrees, the command will be ignored and the corner will remain
- "mitered".
- NOTE: 2 This command will not operate on walls of opposite symmetry
- (direction).
- NOTE: 3 This operation may take some time.
-