home *** CD-ROM | disk | FTP | other *** search
-
-
-
-
-
- MOUSE INSTALLATION
-
-
- Floppy Install
-
- Place your diskette containing mouse driver "GMOUSE.COM into drive A:
- and lower your drive lever.
-
- TYPE
- A:GMOUSE (this procedure wil have to be repeated every time you boot your
- system If you wish to use the mouse.
-
-
-
- This will load your mouse driver into memory. The default opearating
- mode for some of are mice is Mouse Sys Mouse (3 Button), this can be
- changed to Microsoft mode (2 Button) by Pressingand holding any one
- of the three mouse buttons down during power up and
- continue to hold it down until you get to your DOS prompt,
- Then load your mouse driver.
-
-
-
-
-
- HARD DRIVE INSTALLATION
-
-
- Place your diskette containing mouse driver ("GMOUSE.COM" or "GMOUSE.SYS")
- into drive A: and lower your drive lever.
-
- 1> GO TO Harddisk TYPE- C: <ENTER>
-
- 2> Make Directory TYPE- MD GMOUSE <ENTER>
-
- 3> GO to the gmouse TYPE- CD\GMOUSE <ENTER>
- directory.
-
- 4> Copy Mouse driver TYPE- COPY A:\*.*
- and support files
- to current directory.
-
-
- 5> Load mouse Driver. TYPE- GMOUSE 1 or
- GMOUSE 2
- depending upon which comport
- you have your mouse plugged into.
-
- You will have to repeat instruction #5 each time you boot your system
- if you wish to use the mouse.
-
-
- For more information on mouse parameters print the READ.ME file.
-
-
- TO install the mouse driver in your autoexec.bat or config.sys
- refer to your DOS manual.
-
-
- The mouse can only be used with programs that support a mouse.
- Go into the Applications setup program and select Mouse Sys mode or
- Microsoft mode depending upon which mode you set the mouse up for.
-
-
-
-
-
- If you have anymore questions Call KYE Technical Support at (714) 590-8892
-