home *** CD-ROM | disk | FTP | other *** search
- Newsgroups: comp.sys.mac.hardware
- Path: sparky!uunet!mcsun!sunic!corax.udac.uu.se!tdb!bredell
- From: bredell@tdb.uu.se (Mats Bredell)
- Subject: Re: Postscript cmd to turn ON the startup page
- Message-ID: <1993Jan8.082559.17981@tdb.uu.se>
- Reply-To: Mats.Bredell@udac.uu.se
- Organization: Uppsala University Computing Center (UDAC)
- X-Newsreader: TIN [version 1.1 PL6]
- References: <1993Jan7.210859.26665@netcom.com>
- Date: Fri, 8 Jan 1993 08:25:59 GMT
- Lines: 24
-
- Bailey Szeto (bszeto@netcom.com) wrote:
- : Hello all.
- : Does anybody know the postscript command to turn on the startup page for
- : a laserwriter? I need to know the exact command because the printer is not
- : connected to a mac, and therefore, I cannot run the Laserwriter font utility.
- :
- : I believe that there are two ways to accomplish this. One is to connect
- : a terminal straight to the serial port, and the other is to put a postscript
- : header around the postscript command. I need to know what the command is.
- :
- : Any help/info/suggestions/comments would be greatly appreciated! Thanks
- : in advance.
-
- The following is pulled directly off the Developer CD:
-
- serverdict begin 0 exitserver
- statusdict begin true setdostartpage
-
- /Mats
- --
- Mats Bredell Mats.Bredell@udac.uu.se
- Uppsala University Computing Center (UDAC) Ph: +46 18 187817
- Department of medical systems Fax: +46 18 187825
- Sweden Think straight - be gay!
-