home *** CD-ROM | disk | FTP | other *** search
- Newsgroups: comp.sys.mac.apps
- Path: sparky!uunet!zaphod.mps.ohio-state.edu!caen!batcomputer!ghost.dsi.unimi.it!newsserver.di.unipi.it!mac-grandoni.iei.pi.cnr.it!user
- From: grandoni@iei.pi.cnr.it (Fabrizio Grandoni)
- Subject: Claris CAD doesn't love IIfx
- Message-ID: <grandoni-281292131713@mac-grandoni.iei.pi.cnr.it>
- Followup-To: comp.sys.mac.apps
- Sender: netnews@cli.di.unipi.it (USENET News System)
- Nntp-Posting-Host: mac-grandoni.iei.pi.cnr.it
- Organization: IEI-CNR
- Date: Mon, 28 Dec 1992 12:09:24 GMT
- Lines: 25
-
- I tried Claris CAD 2.0 on my macIIfx, finding a strange behaviour: it
- refuses to open more than one (1!) document. Just to test if the program
- were corrupted, I tried it on some SE30 in my dept.: it works as it should.
- Then I tried running it on another IIfx: same result as on mine. With a
- document already open, whether trying to use the OPEN command on another
- document, or to use the NEW file menu command makes me obtain the warning
- "Sorry, there is not enough memory available to open another document".
- This is independent of the memory size set for the application (I set it to
- over 2000 KB), as well as of the system configuration: after first trials
- on sys 7 (even disabling all added extensions) I run the beast under sys
- 6.0.8, obtaining exactly the same results. My mac was originally a IIx,
- where, in a few occasions, I ran ClarisCAD 1.0v5 without problems; then I
- "upgraded" to fx, getting this surprise.
- Final note: even ClarisCAD 1.0v5 now lets me open only one document ...
- Any comment?
- Thanks,
-
- fab
-
- ______________________________________________________________________
- fabrizio grandoni Internet: grandoni@iei.pi.cnr.it
-
- IEI-CNR
- Via S. Maria,46
- 56126 Pisa, Italy
-