home *** CD-ROM | disk | FTP | other *** search
- Path: sparky!uunet!zaphod.mps.ohio-state.edu!usc!news.service.uci.edu!unogate!mvb.saic.com!hoverson
- From: Hoverson@Fwva.Saic.Com (Jeff Hoverson %%% SAIC %%% 619535-7043 %%%)
- Newsgroups: vmsnet.sysmgt
- Subject: Re: Problems configuring LN03 on terminal server
- Message-ID: <9675001@MVB.SAIC.COM>
- Date: Tue, 15 Dec 1992 01:42:32 GMT
- References: <BywF3H.2rn@world.std.com>
- Organization: Science Applications Int'l, Corp. - Computer systems operation
- Lines: 28
-
- reuber@world.std.com (kent b reuber) writes:
- >Having problems configuring and LN03 on a terminal server. System version
- >is VMS 5.3. I can connect the printer and do a TEST PORT 1, I get a test
- >page as expected. But when I try copying to the device, I get the message
- >
- >RMS-F-WER, file write error
- >SYSTEM-F-HANGUP, data set hangup
- >
- >I've checked the name of the server and the port name, but that seems OK.
- >Anything else that looks like a likely snafu. This seems to be an
- >intensely painful process fraught with peril.
-
- We've run into this problem a few times over the past couple of years also.
- Usually it has to do with either the terminal server not being defined properly
- in the NCP database (primarily the name) or the port name is defined
- incorrectly. I believe these names are case-sensitive. Also, we've found, on
- occasion, that another system has channels open to the port that the LN03 is
- connected to , thereby yielding the "data set hangup" messages. You merely
- need to log out the port on the terminal server to resolve this problem.
-
- Good luck!
-
- =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
- Jeff Hoverson | (619)535-7043
- SAIC | Hoverson@Fwva.Saic.Com
- 10260 Campus Point Dr., MS D2 | VAX/VMS System Manager
- San Diego, CA 92121 | But, I coulda' been ....
- =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
-