home *** CD-ROM | disk | FTP | other *** search
- Newsgroups: sci.electronics
- Path: sparky!uunet!zaphod.mps.ohio-state.edu!cs.utexas.edu!torn!newshost.uwo.ca!valve.heart.rri.uwo.ca!wlsmith
- From: wlsmith@valve.heart.rri.uwo.ca (Wayne Smith)
- Subject: Source of AC line spike found: Laminar Hood Blower (MOV problem?)
- Organization: (this space for rent)
- Date: Thu, 17 Dec 1992 02:35:17 GMT
- Message-ID: <1992Dec17.023517.10545@julian.uwo.ca>
- Sender: news@julian.uwo.ca (USENET News System)
- Nntp-Posting-Host: valve.heart.rri.uwo.ca
- Lines: 24
-
- I posted a message a while ago concerning a voltage spike I was seeing
- on the neutral line. Well, we seem to have identified the culprate as
- a blower motor.
-
- The motor is controlled (by some means I haven't check out yet), as it
- regulates the vacuum in a laminar flow hood. You set the vacuum that
- you want (inside the hood relative to the outside) and the motor and
- controller work to achieve that hood vacuum. I think it's an 8 amp
- motor.
-
- I think the company that makes the hood is Laminar. Anyways, with the
- blower turned on, there is a voltage spike on the neutral line that is
- 6 or 7 volts in amplitude and 10 usec in duration and occurrs twice per
- AC cycle.
-
- We also found that plugging in a particular unloaded power bar also
- cause a smaller voltage spike. (this power bar is a little unique in
- that it shuts down its outlets in the event of power outage and then
- it must be manually reset).
-
- The powerbar got me wondering if these MOV (metal oxide varistors) are
- to blame. Do they ring when they experience a potential shift?
- Could they be the problem (if they are used in the blower control
- circuit) or are they part of the solution?
-