home *** CD-ROM | disk | FTP | other *** search
- Path: sparky!uunet!usc!sdd.hp.com!saimiri.primate.wisc.edu!caen!uvaarpa!concert!aurs01!whitcomb
- From: whitcomb@aurs01.UUCP (Jonathan Whitcomb)
- Newsgroups: comp.sys.atari.st.tech
- Subject: Re: Tec and AdSpeed Problem
- Message-ID: <61663@aurs01.UUCP>
- Date: 15 Dec 92 21:57:31 GMT
- References: <A49720@HB.maus.de> <A44242@K.maus.de> <11DEC92.20913780.0237@VM1.MCGILL.CA>
- Sender: news@aurs01.UUCP
- Reply-To: whitcomb@aurxc3.aur.alcatel.com.UUCP (Jonathan Whitcomb)
- Organization: Alcatel Network Systems, Raleigh NC
- Lines: 25
-
- In article <A44242@K.maus.de> Peter_Missel@k.maus.de (Peter Missel) writes:
- > Does anyone have any idea why the TEC board and AdSpeed 16Mhz accelerator
- >will not work on a MEGA in ANYFORM?
-
- >I've had the problem several times, as my daily job is at an Atari dealer. We
- >tried this combination a few times with different TOS expansion cards and
- >several ICD AdSpeed boards. We got one or two machines to run, others wouldn't
- >even boot properly with _any_ combination of TECs and AdSpeeds.
-
- This is probably stating the obvious (like in the trouble-shooting
- section of a new television manual that tells you to make sure the TV is
- plugged in if you don't get a picture), but...
-
- There is a jumper wire that must be soldered between the CPU and the
- expansion slot connector when you install AdSpeed ST in a Mega ST.
- Since the Mega version of the TEC uses the expansion connector, this
- might be a good place to look. Are you sure that the Mega has this
- jumper properly installed?
-
-
-
- **********************************************************************
- Jonathan Whitcomb UUCP: whitcomb%aurgate@mcnc.org
- Alcatel Network Systems
- Raleigh, North Carolina GEnie: J.WHITCOMB3
-