home *** CD-ROM | disk | FTP | other *** search
- Newsgroups: comp.os.os2.misc
- Path: sparky!uunet!zaphod.mps.ohio-state.edu!cs.utexas.edu!qt.cs.utexas.edu!yale.edu!ira.uka.de!math.fu-berlin.de!news.netmbx.de!Germany.EU.net!olymp!rs1.thch.uni-bonn.de!greve
- From: greve@rs1.thch.uni-bonn.de (Thomas Greve)
- Subject: Re: CMS Jumbo 250 use under OS2 2.0
- Message-ID: <1992Dec17.151340.6968@olymp.informatik.uni-bonn.de>
- Sender: usenet@olymp.informatik.uni-bonn.de
- Organization: University of Bonn, phys. Chemistry
- References: <1992Dec12.082445.12080@coyote.datalog.com>
- Date: Thu, 17 Dec 1992 15:13:40 GMT
- Lines: 19
-
- In article <1992Dec12.082445.12080@coyote.datalog.com> ejm@coyote.datalog.com (E.J. McKernan) writes:
- >I just installed OS2 2.0 on a new 486/33. The machine includes a
- >colorado memory systems jumbo 250 tape drive attached to the floppy
- >controller. The entire system is using the HPFS. Now a couple of
- >questions:
- >
- >1. Is there a driver available for the CMS under OS2?
- No. At least not yet. There is a beta version under testing, but
- you'll hear it on this forum first, when they will be ready.
-
- >2. How can I set up a DOS session to run the DOS tape software?
- Use a full screen box with some EMS (about 1Meg), Int_During_IO
- *DISABLED* and idle sensitivity not too low (some seconds of idle
- delay is not bad either). If you encounter SY3176 errors, disable any
- --
- - Thomas
-
- greve@rs1.thch.uni-bonn.de
- unt145@dbnrhrz1
-