home *** CD-ROM | disk | FTP | other *** search
- Path: sparky!uunet!cis.ohio-state.edu!zaphod.mps.ohio-state.edu!uakari.primate.wisc.edu!zazen!doug.cae.wisc.edu!umn.edu!cs.umn.edu!quest!digibd!kas!rhealey
- From: rhealey@kas.helios.mn.org (Rob Healey)
- Newsgroups: comp.unix.amiga
- Subject: Re: sysadm menu
- Message-ID: <1992Jul30.135109.27980@kas.helios.mn.org>
- Date: 30 Jul 92 13:51:09 GMT
- References: <1992Jul22.223717.15030@bernina.ethz.ch>
- Organization: Rob's home system, Hopkins, MN
- Lines: 20
-
- In article <1992Jul22.223717.15030@bernina.ethz.ch> wild@nessie.cs.id.ethz.ch (Markus Wild) writes:
- =I was browsing around /usr/sadm/sysadm, and found that in the add-ons
- =directory, there are lots of help files, not normally available on the
- =sysadm menu. After reading the sysadm man page, I guess those are pre-R4
- =or `alien' help files (`alien' is not that probable, BNU's there as
- =well). Now.. according to the manpage, those help files should be available
- =under their own menu item on the main menu, however, they are not.
- =
- =This is under 2.03, is there a certain command that enables those
- =additional help files? They look nice, and I'd like at least try them
- =out until I decide not to use them ;-))
- =
- A few more are enabled under 2.1 but not all of them. Check out an
- Intel version of SVR4 and then add the missing or incomplete
- files... 2.1 gives access to the printer and FACE config menus. The
- backup/restore menus are still disabled because they are alot
- more complex and were removed by previous maintainers of AmigaUNIX
- who thought them either extraineous or stupid... B^(.
-
- -Rob
-