home *** CD-ROM | disk | FTP | other *** search
- Newsgroups: comp.sys.ibm.ps2.hardware
- Path: sparky!uunet!walter!porthos!navaho!dml7
- From: dml7@navaho.uucp (25635-lee)
- Subject: Re: EMS driver for Mod 50/60 mem expansion
- Reply-To: dml7@navaho.UUCP (25635-lee,danny)
- Organization: Bellcore, Livingston, NJ
- Date: Mon, 27 Jul 92 13:35:02 GMT
- Message-ID: <1992Jul27.133502.3787@porthos.cc.bellcore.com>
- References: <1992Jul23.120305.24057@einoed.in-berlin.de> <1992Jul27.020027.10867@genghis.borland.com>
- Sender: netnews@porthos.cc.bellcore.com (USENET System Software)
- Lines: 21
-
- In article <1992Jul27.020027.10867@genghis.borland.com> jamesc@genghis.borland.com (James Chuang ) writes:
- >
- >I believe your card is a extended memory card. If so, then you should have
- >a certain amount of extended memory. What does your machine report when it
- >boots up?
- >If you have extended memory, just use DOS 5.0's EMM386.EXE, which will
- >provide EMS interface. Check the DOS 5.0 manual on HIMEM.SYS and EMM386.EXE.
- >jamesc
-
- but, isn't emm386.exe only for 386 machines. the model 50/60 are 286
- machines. i have a 50z, and it reads 10mb during boot-up, but i can't
- verify whether i'm utilizing all this memory or not. any suggestions?
- i'm not using any drivers at all (in my config.sys), plus i'm still using
- dos 4.01.
-
- thanks in advance for any help.
-
- /----------------------------------------------
- / Danny / dml7@navaho.cc.bellcore.com /
- / Lee / dml@cunixb.cc.columbia.edu /
- ----------------------------------------------/
-