home *** CD-ROM | disk | FTP | other *** search
- Path: sparky!uunet!elroy.jpl.nasa.gov!ames!agate!ucbvax!TSO.UC.EDU!usr7495a
- From: usr7495a@TSO.UC.EDU (Kevin Cordell)
- Newsgroups: comp.os.vms
- Subject: DHV11 configuration switches
- Message-ID: <9207241619.AA03789@tso.uc.edu>
- Date: 24 Jul 92 16:19:25 GMT
- Sender: daemon@ucbvax.BERKELEY.EDU
- Distribution: world
- Organization: The Internet
- Lines: 43
-
- FORWARDED FROM: /mail/74/usr7495a(#10572) From:INFO-VAX@UBVM.cc.buffalo.edu 07/24/92 04:31
- Reply-To: INFO-VAX@SRI.COM
-
-
- I have a DHV11 (without a manual) for my VaxStation II running VMS 5.5 .
-
- I had the card installed and found that VMS crashed with a bug check in
- kernal mode during the VMS startup phase (bit difficult to know where).
-
- The DHV11 config switches were set DDDDUDUD DDUDDDDU (D=>open) as viewied
- from Q-bus edge connector.
-
- Are the switches set correctly (and the card stuffed) or what are the correct
- settings.
-
- -----FORWARDED BY: usr7495a(Kevin Cordell)
- IN response to the question above.. since you did not post a name or
- an address.. I have the following set on the DHV11 in the MVII that I
- have..
-
- From the card edge connector:
- CSR Address Interrupt Vector
- E58 E43
- 000010011 011000 (switch E43-2 is not used)
-
- where 1= switch on
- 0= switch off
-
- This defines an address of 17760460 (factory default BTW)
- and an Interrupt Vector of 300 (also factory default)
-
- Now I hope that someone else can explain better than I about the addressing
- in the configuration.. I only watched the Digital FE intall the stuff, but
- try to watch everything that he is doing in case I have to do it myself.
-
- kevin
- --------------------------------------------------------------------------
- Kevin J. Cordell Internet:usr7495a@tso.uc.edu
- Information Systems Manager Voice: 513 542-5555
- EG&G Frequency Products, Inc.
- Cincinnati, Ohio 45232
- --------------------------------------------------------------------------
-
-