home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
World of Ham Radio 1997
/
WOHR97_AmSoft_(1997-02-01).iso
/
mods
/
alinco
/
dj510_1.doc
< prev
next >
Wrap
Text File
|
1997-02-01
|
984b
|
29 lines
Alinco DJ-510T
Expnad Reception Range and Enable Cross Band Repeater
Procedure: Expand Reception Range
1. Remove battery and antenna.
2. Remove case attach screws and open unit.
3. Cut YELLOW wire looped around BLUE capacitor.
4. Remove -2- screw from corners of tone board to expose motherboard.
5. Solder a 100 uf 16V electrolytic capacitor with the minus (-) lead
going to pin 8 of M54959P and the (+) plus lead going to the 3rd
pin of socket 9orange wires).
6. Remove front cover.
7. Jumper resistor R35 with small length of wire-wrap wire. Solder
short jumber across pads above R35 and left of VR3.
8. Re-assemble in reverse order.
9. Reset microprocessor by pushing RED reset button.
Procedure: Cross Band Repeater Enable Procedure
select VHF and UHF frequencies and press SHIFT until "DUAL"
appears.
To Turn On: Press and hold REV and trun on power. Volume control
controls amount of repeater audio.
To Turn Off: Turn set off.