home *** CD-ROM | disk | FTP | other *** search
- REM RE_SID: @(%)/usr/re/builds/pcnfs/dos/kernel/drivers/nfsodi/SCCS/s.loadodi.bat 1.2 93/02/07 15:40:18 SMI
-
- REM *** This batch file shows the order in which PC-NFS and NetWare system
- REM *** files must be loaded. The actual file and path names for NetWare
- REM *** are not shown.
- REM ***
- REM *** To use this batch file, replace the place holder path and file names
- REM *** below with the names appropriate for your system. Alternately, copy
- REM *** the following lines into AUTOEXEC.BAT and adjust the names as necessary.
- REM ***
- @echo off
- SET TZ=EST5EDT
- PROMPT $p$g
- PATH C:\DOS;C:\NFS;c:\win31;c:\place\holder\for-netware
- rem
- SET TEMP=C:\DOS
- SET NFSDRIVE=C
- SET NFSPATH=C:\NFS
- SET TN_DIR=C:\NFS\TELNET
- rem
- \place\holder\for-netware\link-support-driver ; e.g. \netware\odi\lsl
- \place\holder\for-netware\board-driver ; e.g. \netware\odi\3c503
- rem
- c:\nfs\prt *
- c:\nfs\net init
- rem
- \place\holder\for-netware\ipx-driver ; e.g. \netware\odi\ipxodi
- \place\holder\for-netware\redirector ; e.g. \netware\odi\netx
- rem
- REM *** Finally, if your Novell network is configured to use Ethernet_802.3
- REM *** encapsulation, add a /b2 switch to the line device=c:\nfs\nfsodi.sys
- REM *** in your CONFIG.SYS file and add an entry in your NET.CFG file
- REM *** defining the two frames types. For example, the relevant lines in
- REM *** CONFIG.SYS may look like:
- REM *** DEVICE=C:\NFS\PCNFS.SYS
- REM *** DEVICE=C:\NFS\SOCKDRV.SYS
- REM *** DEVICE=C:\NFS\NFSODI.SYS /b2
- REM *** LASTDRIVE=L
- REM ***
- REM *** A sample NET.CFG file may look like:
- REM *** LINK DRIVER 3C503
- REM *** INT 2
- REM *** DMA 1
- REM *** PORT 300
- REM *** FRAME ETHERNET_802.3
- REM *** FRAME ETHERNET_II
- REM ***
- rem
-
-
-