home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Chip 1997 October
/
Chip_1997-10_cd.bin
/
ovladace
/
3com
/
3c589n
/
3c589n.exe
/
HELP
/
LANSRV.TXT
< prev
next >
Wrap
Text File
|
1996-11-11
|
3KB
|
129 lines
3Com (R) Corporation
Installing IBM LAN Server 4.0 for DOS and OS/2
OS/2
======
This procedure describes how to install the NDIS driver
for LAN Server 4.0. OS/2 must already be installed on
your computer. To install the NDIS driver for the 3C589
EtherLink III LAN PC Card, follow these steps:
1. Open an OS/2 prompt.
2. Insert the LAN Server MPTS (Multi-Protocol Transport
Services) disk 1 in your diskette drive.
3. Make that drive your current drive. Type:
A: [Enter]
4. Type:
Install [Enter]
5. Select OK.
6. Select Install.
7. Select a target drive and then choose OK,
The default drive is C.
8. Insert disk 2 when prompted and select OK.
9. Select OK when the MPTS installation is complete.
10. Select Configure.
11. Select LAN Adapters and Protocols
and then choose Configure.
12. Select Other Adapters and then choose OK.
13. Insert the 3Com EtherDisk diskette in the
diskette drive and enter the drive letter and path to
the 3Com NDIS drivers. For example, type:
A:\NDIS\OS2
14. Select OK.
15. Select 3Com EtherLink III PC Card for
OS/2 and then choose Add.
16. Under Current Configuration, select 3Com
EtherLink III PC Card for OS/2 and then choose
Edit.
17. Enter the 12-digit address of your EtherLink
III LAN PC Card and then choose OK.
The address is found on the back of the
PC Card following the characters EA=.
18. Select the protocol(s) you will be using with
your network and then choose Add.
19. Select your protocol(s) under Current
Configuration and then choose Edit.
20. Enter the 12-digit address of your
EtherLink III LAN PC card and then choose OK.
21. Select OK.
22. Select Close.
23. Select Exit.
24. Select Update CONFIG.SYS and choose Exit.
25. Select OK.
26. Select Exit.
27. Quit OS/2 and reboot for the changes to take effect.
28. Follow the IBM instructions on installing
LAN Server to complete the installation.
DOS
======
IBM DOS Lan Services Install v4.0
1. Insert the disk labeled "Dos Lan Services Disk 1" into
your disk drive.
2. Change to that drive and type in "INSTALL"
3. Choose the directory you want the software installed to.
The default is "C:\NET".
4. A menu will appear that provides a list of Network Cards.
Choose "Network card not shown in the list below..."
5. Type in "A:\IBM_40 and remove the "Dos Lan Services Disk 1"
diskette and insert the EtherDisk.
6. The next menu should display "3Com 3C589 EtherLink III
PC Card.
7. Additional menus will appear, choose the appropriate options
for your network environment. Refer to the IBM manual if
there are questions regarding these menus.
8. After completing the installation you must copy ELPC3X.DOS
to C:\NET before rebooting.
=========================================================
(%VER NDIS - IBM LAN Server v2.1c)