128 By selecting this particular media type, the corresponding duplex setting has been automatically updated.
129 By selecting this particular duplex, the corresponding media settings has been automatically updated.
130 Bus master mode not set for slot, setting for this session.
131 Bus master mode not supported for this slot, please move EtherLink XL adapter to another slot or consult your BIOS reference.
132 The media type cannot be automatically selected at this time. Please check the media type configuration and change if necessary.
133 Unable to locate the echo server (request has timed-out).
134 NIC failed while transmitting request to server. Problem is typically caused by either cabling problem or NIC failure.
135 Improper packet sequence number detected.
136 NIC failure during initialization. Please check the transceiver type settings of the client and server.
137 Unable to transmit packet(s).
138 Unable to receive packet(s).
139 Failure trying to receive packets. Please check if the server is still responding.
140 This program requires the DOS driver versions to be 2.0 or higher. Another alternative is to unload all 3Com drivers before running this program.
141 This program requires the NDIS driver version to be 2.0 or higher. Another alternative is to unload all 3Com drivers before running this program.
142 Failure while trying to receive packets. Please check your network connection.
143 NIC failed during echo test. Try the test again. If failure persists, swap with a known good NIC and try again.
144 This NIC does not support the optimal settings option.
145 The NIC is not currently connected to a network. Please check the media type connections of the client and server and change if necessary.
147 Carrier Lost register test failed.
148 Frames Deferred register test failed.
149 Frames Received OK register test failed.
150 Frames Transmitted OK register test failed.
151 Internal Configuration register test failed.
152 Late Collisions register test failed.
153 Mac Control register test failed.
154 Master Address register test failed.
155 Master Length register test failed.
156 Media Status register test failed.
157 Multiple Collisions register test failed.
158 Network Diagnostic register test failed.
159 Rx Overrun register test failed.
160 Single Collision Frames register test failed.
161 SQE Errors register test failed.
162 Station Address 0 register test failed.
163 Station Address 2 register test failed.
164 Station Address 4 register test failed.
165 Station Mask 0 register test failed.
166 Station Mask 2 register test failed.
167 Station Mask 4 register test failed.
168 IntStatus Command register test failed.
169 Indication Enable register test failed.
170 Interrupt Enable register test failed.
171 Rx Early Threshold register test failed.
172 Tx Available Threshold register test failed.
173 Tx Start Threshold register test failed.
174 Unable to get the checksum from the EEPROM.
175 Miscompare between the checksum stored in the EEPROM and the calculated value.
176 Unable to initialize NIC for the FIFO loopback test.
177 Unable to transmit frame during loopback test.
178 Unable to receive frame during loopback test.
179 Mismatch between transmit size and receive size.
180 Mismatch between transmit data and receive data.
181 Unable to initialize NIC for the Core loopback test.
182 Unable to initialize NIC for the Encoder/Decoder loopback test.
183 WARNING: Please make sure that all the drivers are current and properly installed before running this program. Otherwise, there may be a conflict.
184 In order to run this program under Windows 95, the 3Com NDIS Desktop Agent must be installed.
185 This program requires the NDIS driver version to be 2.0 or higher.
186 Since the previous setting was in auto mode, the duplex setting has been updated. Please make sure that the duplex and media settings actually reflect the current network.
187 The NIC has invalid resources assigned. Please make sure that the system BIOS is properly configured else try updating the BIOS.