home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
OS/2 Shareware BBS: 33 VDrivers
/
33-VDrivers.zip
/
vppci101.zip
/
vpros2wn.txt
< prev
next >
Wrap
Text File
|
1994-06-02
|
1KB
|
49 lines
OS/2 for Windows Install Instructions
for the Viper Version 1.0
These instructions assume that the Viper has already been installed under the
DOS/Windows environment using a default installation. If you located the
Viper files and utilities in a different location, change the paths below as
appropriate.
1. Install OS/2 for Windows using the standard VGA driver.
2. Install the Viper OS/2 2.1 drivers per the instructions included with
those drivers.
3. Open up an OS/2 windowed or full screen command prompt. Type the
following two commands:
COPY Y:\OS2\MDOS\WINOS2\*.* Z:\WINDOWS
COPY Y:\OS2\MDOS\WINOS2\SYSTEM\*.* Z:\WINDOWS\SYSTEM
Y is the drive where OS/2 for Windows has been installed.
Z is the drive where Microsoft Windows has been installed.
4. Edit your SYSTEM.INI file (it is located in the Windows directory). There
should be a line that reads:
fdisplay.drv=vga.drv
Change this to read as follows:
If you selected 256 colors, the line should read:
fdisplay.drv=p9000_08.drv
If you selected 65,000 colors, the line should read:
fdisplay.drv=p9000_16.drv
If you selected 16.7 million colors, the line should read:
fdisplay.drv=p9000_32.drv
Save the SYSTEM.INI file.
5. You should now be able to run Windows applications seamlessly and full-
screen under OS/2 for Windows with the Viper.